Hi,
On Wednesday 05 June 2013 10:34 PM, Dan Murphy wrote:
> Sricharan
>
> Thanks for sending this up in the series.
>
> On 06/05/2013 01:46 AM, Sricharan R wrote:
>> From: Dan Murphy <dmurphy@xxxxxx>
>>
>> Add support for blue LED 1 off of GPIO 153.
>> Make the LED a heartbeat LED
>> Configure the MUX for GPIO output.
>>
>> Cc: Dan Murphy <dmurphy@xxxxxx>
>> Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
>> [Sricharan R <r.sricharan@xxxxxx>: Replaced constants with preprocessor macros]
>> Signed-off-by: Sricharan R <r.sricharan@xxxxxx>
>> ---
>> arch/arm/boot/dts/omap5-uevm.dts | 17 +++++++++++++++++
>> 1 file changed, 17 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/omap5-uevm.dts b/arch/arm/boot/dts/omap5-uevm.dts
>> index cf862df..a2aed5b 100644
>> --- a/arch/arm/boot/dts/omap5-uevm.dts
>> +++ b/arch/arm/boot/dts/omap5-uevm.dts
>> @@ -66,6 +66,16 @@
>> device = <&hsusb2_phy>;
>> clock-frequency = <19200000>; /* 19.2 MHz */
>> };
>> +
>> + leds {
>> + compatible = "gpio-leds";
>> + led@1 {
>> + label = "omap5:blue:usr1";
>> + gpios = <&gpio5 25 GPIO_ACTIVE_HIGH>; /* gpio5_153 D1 LED */
>> + linux,default-trigger = "heartbeat";
>> + default-state = "off";
>> + };
>> + };
>> };
>>
>> &omap5_pmx_core {
>> @@ -77,6 +87,7 @@
>> &mcbsp1_pins
>> &mcbsp2_pins
>> &usbhost_pins
>> + &led_gpio_pins
>> >;
>>
>> twl6040_pins: pinmux_twl6040_pins {
>> @@ -175,6 +186,12 @@
>> 0x6e (PIN_OUTPUT | MUX_MODE6) /* gpio3_79 OUTPUT | MODE 6 ETH_NRESET */
>> >;
>> };
>> +
>> + led_gpio_pins: pinmux_led_gpio_pins {
>> + pinctrl-single,pins = <
>> + 0x196 (PIN_OUTPUT | MUX_MODE6) /* uart3_cts_rctx.gpio5_153 OUTPUT | MODE6 */
> Same comment from Florian. We can drop the OUTPUT | MODE6 in the comment.
Ok thanks, Corrected in V2.
Regards,
Sricharan
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
