Sricharan
Thanks for sending this up in the series.
On 06/05/2013 01:46 AM, Sricharan R wrote:
> From: Dan Murphy <dmurphy@xxxxxx>
>
> Add support for blue LED 1 off of GPIO 153.
> Make the LED a heartbeat LED
> Configure the MUX for GPIO output.
>
> Cc: Dan Murphy <dmurphy@xxxxxx>
> Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
> [Sricharan R <r.sricharan@xxxxxx>: Replaced constants with preprocessor macros]
> Signed-off-by: Sricharan R <r.sricharan@xxxxxx>
> ---
> arch/arm/boot/dts/omap5-uevm.dts | 17 +++++++++++++++++
> 1 file changed, 17 insertions(+)
>
> diff --git a/arch/arm/boot/dts/omap5-uevm.dts b/arch/arm/boot/dts/omap5-uevm.dts
> index cf862df..a2aed5b 100644
> --- a/arch/arm/boot/dts/omap5-uevm.dts
> +++ b/arch/arm/boot/dts/omap5-uevm.dts
> @@ -66,6 +66,16 @@
> device = <&hsusb2_phy>;
> clock-frequency = <19200000>; /* 19.2 MHz */
> };
> +
> + leds {
> + compatible = "gpio-leds";
> + led@1 {
> + label = "omap5:blue:usr1";
> + gpios = <&gpio5 25 GPIO_ACTIVE_HIGH>; /* gpio5_153 D1 LED */
> + linux,default-trigger = "heartbeat";
> + default-state = "off";
> + };
> + };
> };
>
> &omap5_pmx_core {
> @@ -77,6 +87,7 @@
> &mcbsp1_pins
> &mcbsp2_pins
> &usbhost_pins
> + &led_gpio_pins
> >;
>
> twl6040_pins: pinmux_twl6040_pins {
> @@ -175,6 +186,12 @@
> 0x6e (PIN_OUTPUT | MUX_MODE6) /* gpio3_79 OUTPUT | MODE 6 ETH_NRESET */
> >;
> };
> +
> + led_gpio_pins: pinmux_led_gpio_pins {
> + pinctrl-single,pins = <
> + 0x196 (PIN_OUTPUT | MUX_MODE6) /* uart3_cts_rctx.gpio5_153 OUTPUT | MODE6 */
Same comment from Florian. We can drop the OUTPUT | MODE6 in the comment.
> + >;
> + };
> };
>
> &omap5_pmx_wkup {
--
------------------
Dan Murphy
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
