From: Koen Kooi <koen@xxxxxxxxxxxxxxx> TFP410 DVI chip is used to provide display out. this chip is controlled by 2 lines: LDO which supplies the power is controlled over gpio + 2 and the enable of the chip itself is done over gpio + 1 NOTE: the LDO is necessary for LED, serial blocks as well. GPIO + 1 was used to sense USB overcurrent in vanilla beagle [nm@xxxxxx: helped split up the patch] Signed-off-by: Nishanth Menon <nm@xxxxxx> Signed-off-by: Koen Kooi <koen@xxxxxxxxxxxxxxx> --- arch/arm/mach-omap2/board-omap3beagle.c | 20 +++++++++++++++++--- 1 files changed, 17 insertions(+), 3 deletions(-) diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c index d628f5e..7c82730 100644 --- a/arch/arm/mach-omap2/board-omap3beagle.c +++ b/arch/arm/mach-omap2/board-omap3beagle.c @@ -293,9 +293,10 @@ static int beagle_twl_gpio_setup(struct device *dev, /* REVISIT: need ehci-omap hooks for external VBUS * power switch and overcurrent detect */ - - gpio_request(gpio + 1, "EHCI_nOC"); - gpio_direction_input(gpio + 1); + if (omap3_beagle_get_rev() != OMAP3BEAGLE_BOARD_XM) { + gpio_request(gpio + 1, "EHCI_nOC"); + gpio_direction_input(gpio + 1); + } /* * TWL4030_GPIO_MAX + 0 == ledA, EHCI nEN_USB_PWR (out, XM active @@ -317,6 +318,19 @@ static int beagle_twl_gpio_setup(struct device *dev, /* TWL4030_GPIO_MAX + 1 == ledB, PMU_STAT (out, active low LED) */ gpio_leds[2].gpio = gpio + TWL4030_GPIO_MAX + 1; + /* + * gpio + 1 on Xm controls the TFP410's enable line (active low) + * gpio + 2 control varies depending on the board rev as follows: + * P7/P8 revisions(prototype): Camera EN + * A2+ revisions (production): LDO (supplies DVI, serial, led blocks) + */ + if (omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_XM) { + gpio_request(gpio + 1, "nDVI_PWR_EN"); + gpio_direction_output(gpio + 1, 0); + gpio_request(gpio + 2, "DVI_LDO_EN"); + gpio_direction_output(gpio + 2, 1); + } + return 0; } -- 1.6.3.3 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html