Adding minimal board support for LogicPD's LV_SOM and Torpedo devkits. This mainly includes only Serial, Ethernet and SD card support for now. This was tested (and based) against 2.6.36-rc5. >From the prior set of patches the following is what I've changed: - Added in a fifth patch that configures UART1 for low level debug support on the LV_SOM and Torpedo Differences from Patch v2 1/4: - I've removed the init_sdram() functions and have passed NULL into sdrc parameters for omap2_init_common_hw(). This is mainly because we have multiple revisions of these boards that contain different memory settings and since we currently don't have any code in the kernel for detecting which revision is being used (it is possible and will be done later), we will leave it up to the boot loader to correctly setup the memory timings. - Modified the description slightly in Kconfig so that the LV_SOM and torpedo were consistent in their naming. Removed a couple of trailing spaces here as well - Fixed indentation of "vmmc", line inside omap3logic_vmmc1_supply - Removed omap3logic_map_io() and replaced with generic omap3_map_io(). These functions were identical and it didn't make sense to have the local board one. - Removed addition of boards to omap2_defconfig, and added "default y" to both boards in Kconfig Differences from Patch v2 2/4: - Moved comments in board_mmc_init() relating to which board was detected to inside each each conditional portion of code rather than immediately above the given code section Differences from Patch v2 3/4: - No changes Differences from Patch v2 4/4: - Moved the omap3torpedo_fix_pbias_voltage() out to part of the omap3logic_init() function rather than being called from within the SMSC911x init function. This is because there are other IRQ lines that also use the pins affected by having the rail turned on for these GPIO pins. - Moved the comments to just inside the conditionals for lv_som versus torpedo selection in board_smsc911x_init(), rather than above the conditionals of each. - Removed dead code from within board_smsc911x_init(). Note: I am taking over from Jacob Tanenbaum's earlier patches that were submitted in August. I wasn't sure entirely what the protocol was, so these are all signed by me. Tim Nordell (5): Adding LogicPD OMAP3 board support ARM: OMAP3LOGIC: Adding SDMMC support ARM: OMAP3: Add generic smsc911x support when connected to GPMC ARM: OMAP3LOGIC: Added SMSC Ethernet board support ARM: OMAP3LOGIC: Adding low-level debug support arch/arm/mach-omap2/Kconfig | 18 ++ arch/arm/mach-omap2/Makefile | 7 + arch/arm/mach-omap2/board-omap3logic.c | 244 +++++++++++++++++++++++ arch/arm/mach-omap2/gpmc-smsc911x.c | 113 +++++++++++ arch/arm/plat-omap/include/plat/gpmc-smsc911x.h | 35 ++++ arch/arm/plat-omap/include/plat/uncompress.h | 2 + 6 files changed, 419 insertions(+), 0 deletions(-) create mode 100644 arch/arm/mach-omap2/board-omap3logic.c create mode 100644 arch/arm/mach-omap2/gpmc-smsc911x.c create mode 100644 arch/arm/plat-omap/include/plat/gpmc-smsc911x.h -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
