> -----Original Message----- > From: linux-omap-owner@xxxxxxxxxxxxxxx > [mailto:linux-omap-owner@xxxxxxxxxxxxxxx] On Behalf Of Premi, Sanjeev > Sent: Wednesday, November 04, 2009 7:32 PM > To: Kevin Hilman > Cc: Reddy, Teerth; linux-omap@xxxxxxxxxxxxxxx > Subject: RE: [PATCH]OMAP3:PM :T2 keypad wakeup for OMAP3 [snip] --- [snip] > > > Teerth, Kevin, > > > > > > Did you test it with OFF mode enabled? > > > > I tested on SDP, but not on omap3evm since that was the only board > > file touched by this patch. > > > > > When I do "echo 1 > /sys/power/enable_off_mode" I don't see > > resume on the omap3evm. > > > > > > Schematics for the keypad are/seem to be same for EVM and SDP. > > > > I'm guessing that it's because the patch from Teerth only muxes this > > pin for the SDP. I'm guessing that doing the same > omap_cfg_reg in the > > OMAP3EVM board file will get this working. > > > > Kevin > > > > Kevin, > > I have done the corresponding changes. See: > 1) http://marc.info/?l=linux-omap&m=125725494430834&w=2 > 2) http://marc.info/?l=linux-omap&m=125725495630852&w=2 > 3) http://marc.info/?l=linux-omap&m=125725498430876&w=2 > > If I do suspend with OFF mode enabled (enable_off_mode=1), and > all power domains transition to target state, the key press > doesn't resume the system. > > But, with this flag off OR any power domain didn't transition to > the target state. The key press brings system out of 'suspend'. > Can someone with a 3430SDP or ZOOM board try this scenario? I am trying to understand if it is a generic problem OR specific to the omap3evm. Best regards, Sanjeev -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
