Nishanth Menon <menon.nishanth@xxxxxxxxx> writes:
> Kevin Hilman said the following on 10/01/2009 06:58 PM:
>> From: Rajendra Nayak <rnayak@xxxxxx>
>>
>> Signed-off-by: Rajendra Nayak <rnayak@xxxxxx>
>> ---
>> arch/arm/plat-omap/gpio.c | 92 ++++++++++++++++++++++++++++++++
>> arch/arm/plat-omap/include/mach/gpio.h | 3 +-
>> 2 files changed, 94 insertions(+), 1 deletions(-)
>>
>> diff --git a/arch/arm/plat-omap/gpio.c b/arch/arm/plat-omap/gpio.c
>> index b0c7361..9850ade 100644
>> --- a/arch/arm/plat-omap/gpio.c
>> +++ b/arch/arm/plat-omap/gpio.c
>> +
>> +/* restore the required registers of bank 2-6 */
>> +void omap3_gpio_restore_context(void)
>> +{
>> + int i;
>> + for (i = 1; i < gpio_bank_count; i++) {
>> + struct gpio_bank *bank = &gpio_bank[i];
>> + __raw_writel(gpio_context[i].sysconfig,
>> + bank->base + OMAP24XX_GPIO_SYSCONFIG);
>> + __raw_writel(gpio_context[i].irqenable1,
>> + bank->base + OMAP24XX_GPIO_IRQENABLE1);
>> + __raw_writel(gpio_context[i].irqenable2,
>> + bank->base + OMAP24XX_GPIO_IRQENABLE2);
>>
> do you want to write to the IRQENABLE register even before configuring
> the rest of the registers (such as data direction etc?
> usually my understanding was:
> configure the device,
> enable the irq..
IIUC, the save/restore sequence was taken directly from TI internal
kernels, so I'm not sure of the history there. Rajendra should speak
to that as the original author of this patch.
That being said, this sequence is being done in the idle path with
interrupts disabled, so by the time interrupts are enabled, the GPIO
banks will be fully configured.
Kevin
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
