Hi, * Pali Rohár <pali.rohar@xxxxxxxxx> [160109 07:16]: > Hello, > > when I boot 4.4.0-rc7+ kernel compiled with g_nokia into zImage on Nokia > N900 into userspace then usb gadget (g_nokia) does not work. Notebook, > connected on other side does not see any usb device... Connecting and > disconnecting cable does not change anything, still not work. > > But if I run this command > $ echo peripheral > /sys/bus/platform/devices/musb-hdrc.0.auto/mode > > then gadget starts working. Other side see usb device and can use it. > Also connecting and disconnecting usb cable working fine. After > connecting it again, usb device OK. N900 had the PHY interrupt wired to the bq chip instead of twl4030, right? You can fix this issue similar to phy-twl4030-usb.c. In function twl4030_phy_power_on() we call schedule_delayed_work() that checks the state of the ID pin on boot up. I think that's only needed for the i2c based PHY's with MUSB, with the others the USB driver has a better idea of the current state. Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
