On 01/04/2016 06:37 PM, Tony Lindgren wrote:
* Russell King - ARM Linux <linux@xxxxxxxxxxxxxxxx> [160104 06:43]:
On Mon, Jan 04, 2016 at 03:27:57PM +0200, Tero Kristo wrote:
On 01/04/2016 12:21 PM, Geert Uytterhoeven wrote:
FWIW, there are small loops with just a cpu_relax() in various clock drivers
under drivers/clk/shmobile/.
Just did a quick profiling round, and the clk_enable/disable delay loops
take anything from 0...1500ns, most typically consuming some 400-600ns. So,
based on this, dropping the udelay and adding cpu_relax instead looks like a
good change. I just verified that changing the udelay to cpu_relax works
fine also, I just need to change the bail-out period to be something sane.
Was that profiling done with lockdep/lock debugging enabled or disabled?
omap2plus_defconfig, so lockdep was enabled. The profiling was done
around the while {} block though, which should not have any locks within
it (except for the SCM clocks, which may explain some of the higher
latency numbers seen.)
And also the thing to check from the hw folks is what all do these clkctrl
bits really control. If they group together the OCP clock and an extra
functional clock for some devices the delays could be larger.
Does it matter really? The latencies are only imposed to the device in
question, and lets face it, the same latencies are there already with
the hwmod implementation. This series moves the implementation under
clock driver with as less modifications as possible to avoid any problems.
In general, I think we need to get rid of pm_runtime_irq_safe usage to
allow clocks to sleep properly. The other option is to allow toggling
pm_runtime_irq_safe but that probably gets super messy.
That is something not to be done with this set though.
-Tero
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
