Re: [PATCH v2 2/3] wlcore/wl12xx: spi: add device tree support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Grygorii,

On 12/24/2015 06:32 PM, Grygorii Strashko wrote:
On 12/24/2015 05:35 PM, Uri Mashiach wrote:
Add DT support for the wl1271 SPI WiFi.

Add documentation file for the wl1271 SPI WiFi.

Signed-off-by: Uri Mashiach <uri.mashiach@xxxxxxxxxxxxxx>
Acked-by: Igor Grinberg <grinberg@xxxxxxxxxxxxxx>
---
v1 -> v2: update interrupt documentation.
            replace interrupts and interrupt-parent with interrupts-extended.
	  IRQ parameters retrieved from spi_device instead of DT.
	  remove redundant #ifdef CONFIG_OF

   .../bindings/net/wireless/ti,wlcore,spi.txt        | 34 +++++++++++++
   drivers/net/wireless/ti/wlcore/spi.c               | 55 ++++++++++++++++++++--
   2 files changed, 85 insertions(+), 4 deletions(-)
   create mode 100644 Documentation/devicetree/bindings/net/wireless/ti,wlcore,spi.txt

diff --git a/Documentation/devicetree/bindings/net/wireless/ti,wlcore,spi.txt b/Documentation/devicetree/bindings/net/wireless/ti,wlcore,spi.txt
new file mode 100644
index 0000000..502c27e
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/wireless/ti,wlcore,spi.txt
@@ -0,0 +1,34 @@
+* Texas Instruments wl1271 wireless lan controller
+
+The wl1271 chip can be connected via SPI or via SDIO. This
+document describes the binding for the SPI connected chip.
+
+Required properties:
+- compatible :          Should be "ti,wl1271"
+- reg :                 Chip select address of device
+- spi-max-frequency :   Maximum SPI clocking speed of device in Hz
+- ref-clock-frequency : Reference clock frequency
+- interrupts-extended : Should contain parameters for 1 interrupt line.
+                        Interrupt parameters: parent, line number, type.
+- vwlan-supply :        Point the node of the regulator that powers/enable the wl1271 chip
+
+Optional properties:
+- clock-xtal :          boolean, clock is generated from XTAL
+
+- Please consult Documentation/devicetree/bindings/spi/spi-bus.txt
+  for optional SPI connection related properties,
+
+Examples:
+
+&spi1 {
+	wl1271@1 {
+		compatible = "ti,wl1271";
+
+		reg = <1>;
+		spi-max-frequency = <48000000>;
+		clock-xtal;
+		ref-clock-frequency = <38400000>;
+		interrupts-extended = <&gpio3 8 IRQ_TYPE_LEVEL_HIGH>;
+		vwlan-supply = <&vwlan_fixed>;
+	};
+};
diff --git a/drivers/net/wireless/ti/wlcore/spi.c b/drivers/net/wireless/ti/wlcore/spi.c
index d3a4bcb..e9e8d54 100644
--- a/drivers/net/wireless/ti/wlcore/spi.c
+++ b/drivers/net/wireless/ti/wlcore/spi.c
@@ -30,6 +30,7 @@
   #include <linux/spi/spi.h>
   #include <linux/wl12xx.h>
   #include <linux/platform_device.h>
+#include <linux/of_irq.h>
   #include <linux/regulator/consumer.h>

   #include "wlcore.h"
@@ -357,6 +358,46 @@ static struct wl1271_if_operations spi_ops = {
   	.set_block_size = NULL,
   };

+#ifdef CONFIG_OF
+static const struct of_device_id wlcore_spi_of_match_table[] = {
+	{ .compatible = "ti,wl1271" },
+	{ }
+};
+
+/**
+ * wlcore_probe_of - DT node parsing.
+ * @spi: SPI slave device parameters.
+ * @res: resource parameters.
+ * @glue: wl12xx SPI bus to slave device glue parameters.
+ * @pdev_data: wlcore device parameters
+ */
+static int wlcore_probe_of(struct spi_device *spi, struct wl12xx_spi_glue *glue,
+			   struct wlcore_platdev_data *pdev_data)
+{
+	struct device_node *dt_node = spi->dev.of_node;
+	int ret;
+
+	if (of_find_property(dt_node, "clock-xtal", NULL))
+		pdev_data->ref_clock_xtal = true;
+
+	ret = of_property_read_u32(dt_node, "ref-clock-frequency",
+				   &pdev_data->ref_clock_freq);
+	if (IS_ERR_VALUE(ret)) {
+		dev_err(glue->dev,
+			"can't get reference clock frequency (%d)\n", ret);
+		return ret;
+	}
+
+	return 0;
+}
+#else /* CONFIG_OF */
+static int wlcore_probe_of(struct spi_device *spi, struct wl12xx_spi_glue *glue,
+			   struct wlcore_platdev_data *pdev_data)
+{
+	return -ENODATA;
+}
+#endif /* CONFIG_OF */

My question for your v1 was related to all above ifdefs.
If CONFIG_OF=n is not going to be supported then all this ifdefs
can be dropped and proper dependency can be added to Kconfig instead.


Will be done in v3.

+
   static int wl1271_probe(struct spi_device *spi)
   {
   	struct wl12xx_spi_glue *glue;
@@ -366,8 +407,6 @@ static int wl1271_probe(struct spi_device *spi)

   	memset(&pdev_data, 0x00, sizeof(pdev_data));

-	/* TODO: add DT parsing when needed */
-
   	pdev_data.if_ops = &spi_ops;

   	glue = devm_kzalloc(&spi->dev, sizeof(*glue), GFP_KERNEL);
@@ -390,6 +429,13 @@ static int wl1271_probe(struct spi_device *spi)
   		return PTR_ERR(glue->reg);
   	}

+	ret = wlcore_probe_of(spi, glue, &pdev_data);
+	if (IS_ERR_VALUE(ret)) {
+		dev_err(glue->dev,
+			"can't get device tree parameters (%d)\n", ret);
+		return ret;
+	}
+
   	ret = spi_setup(spi);
   	if (ret < 0) {
   		dev_err(glue->dev, "spi_setup failed\n");
@@ -407,7 +453,8 @@ static int wl1271_probe(struct spi_device *spi)
   	memset(res, 0x00, sizeof(res));

   	res[0].start = spi->irq;
-	res[0].flags = IORESOURCE_IRQ;
+	res[0].flags = IORESOURCE_IRQ |
+			irqd_get_trigger_type(irq_get_irq_data(spi->irq));


irq_get_trigger_type()?


Will be replaced in v3.

   	res[0].name = "irq";

   	ret = platform_device_add_resources(glue->core, res, ARRAY_SIZE(res));
@@ -445,10 +492,10 @@ static int wl1271_remove(struct spi_device *spi)
   	return 0;
   }

-
   static struct spi_driver wl1271_spi_driver = {
   	.driver = {
   		.name		= "wl1271_spi",
+		.of_match_table = of_match_ptr(wlcore_spi_of_match_table),
   	},

   	.probe		= wl1271_probe,


Sorry for delayed replay.


--
Thanks,
Uri
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Linux Arm (vger)]     [ARM Kernel]     [ARM MSM]     [Linux Tegra]     [Linux WPAN Networking]     [Linux Wireless Networking]     [Maemo Users]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Trails]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux