Hello Pekon,
On Fri, May 9, 2014 at 10:46 PM, Pekon Gupta <pekon@xxxxxx> wrote:
> 1) NAND device memory is not directly accessible to CPU, its indirectly accessed
> via registers. So the 'reg' property for GPMC NAND nodes should be limited to
> address range of internal GPMC registers only.
> 2) Also, minimum granularity of address space under a GPMC chip-select is 16MB
> so 'range' property for GPMC NAND node should specify 16MB as its memory-size
This is true for all SoC using the GPMC right? So we need to do the
same modification for all OMAP boards to avoid mapping a bigger
address space unnecessarily.
> 3) On AM437x, address map of external memory accessible via GPMC starts from 0x0
>
You are talking about AM437x here but changing an am335x board. Is this a typo?
Best regards,
Javier
> Signed-off-by: Pekon Gupta <pekon@xxxxxx>
> ---
> arch/arm/boot/dts/am335x-evm.dts | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm/boot/dts/am335x-evm.dts b/arch/arm/boot/dts/am335x-evm.dts
> index 33f7c57..bae7575 100644
> --- a/arch/arm/boot/dts/am335x-evm.dts
> +++ b/arch/arm/boot/dts/am335x-evm.dts
> @@ -437,9 +437,9 @@
> status = "okay";
> pinctrl-names = "default";
> pinctrl-0 = <&nandflash_pins_s0>;
> - ranges = <0 0 0x08000000 0x10000000>; /* CS0: NAND */
> + ranges = <0 0 0 0x1000000>; /* CS0: NAND */
> nand@0,0 {
> - reg = <0 0 0>; /* CS0, offset 0 */
> + reg = <0 0 0x380>; /* CS0, offset=0, reg-map size=0x380 */
> ti,nand-ecc-opt = "bch8";
> ti,elm-id = <&elm>;
> nand-bus-width = <8>;
> --
> 1.8.5.1.163.gd7aced9
>
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
