On Fri, Dec 05, 2008 at 12:06:27PM -0800, Tony Lindgren wrote: > +#include <linux/clk.h> Not required. > +#include <linux/delay.h> Not required. > +#include <linux/err.h> Not required. > +#include <linux/init.h> > +#include <linux/io.h> May not be required. > +#include <linux/kernel.h> > +#include <linux/platform_device.h> > + > +#include <linux/spi/spi.h> > +#include <linux/spi/ads7846.h> > +#include <linux/i2c/twl4030.h> > + > +#include <linux/mtd/mtd.h> > +#include <linux/mtd/nand.h> > +#include <linux/mtd/partitions.h> > + > +#include <asm/mach-types.h> > +#include <asm/mach/arch.h> > +#include <asm/mach/flash.h> > +#include <asm/mach/map.h> > + > +#include <mach/board.h> > +#include <mach/common.h> > +#include <mach/gpio.h> > +#include <mach/gpmc.h> > +#include <mach/hardware.h> > +#include <mach/nand.h> > +#include <mach/mcspi.h> > + > +#define NAND_BLOCK_SIZE SZ_128K > +#define GPMC_CS0_BASE 0x60 > +#define GPMC_CS_SIZE 0x30 > + > +#define OMAP3_PANDORA_TS_GPIO 94 > + > +static struct mtd_partition omap3pandora_nand_partitions[] = { > + { > + .name = "xloader", > + .offset = 0, /* Offset = 0x00000 */ > + .size = 4 * NAND_BLOCK_SIZE, > + .mask_flags = MTD_WRITEABLE > + }, { > + .name = "uboot", > + .offset = MTDPART_OFS_APPEND, /* Offset = 0x80000 */ > + .size = 14 * NAND_BLOCK_SIZE, > + }, { > + .name = "uboot environment", > + .offset = MTDPART_OFS_APPEND, /* Offset = 0x240000 */ > + .size = 2 * NAND_BLOCK_SIZE, > + }, { > + .name = "linux", > + .offset = MTDPART_OFS_APPEND, /* Offset = 0x280000 */ > + .size = 32 * NAND_BLOCK_SIZE, > + }, { > + .name = "rootfs", > + .offset = MTDPART_OFS_APPEND, /* Offset = 0x680000 */ > + .size = MTDPART_SIZ_FULL, > + }, > +}; > + > +static struct omap_nand_platform_data omap3pandora_nand_data = { > + .parts = omap3pandora_nand_partitions, > + .nr_parts = ARRAY_SIZE(omap3pandora_nand_partitions), > + .dma_channel = -1, /* disable DMA in OMAP NAND driver */ > +}; > + > +static struct resource omap3pandora_nand_resource[] = { > + { > + .flags = IORESOURCE_MEM, > + }, > +}; > + > +static struct platform_device omap3pandora_nand_device = { > + .name = "omap2-nand", > + .id = -1, > + .dev = { > + .platform_data = &omap3pandora_nand_data, > + }, > + .num_resources = ARRAY_SIZE(omap3pandora_nand_resource), > + .resource = omap3pandora_nand_resource, > +}; > + > +static void __init omap3pandora_flash_init(void) > +{ > + u8 cs = 0; > + u8 nandcs = GPMC_CS_NUM + 1; > + > + u32 gpmc_base_add = OMAP34XX_GPMC_VIRT; If it's a virtual address why is it an integer? > + > + /* find out the chip-select on which NAND exists */ > + while (cs < GPMC_CS_NUM) { > + u32 ret = 0; > + ret = gpmc_cs_read_reg(cs, GPMC_CS_CONFIG1); > + > + if ((ret & 0xC00) == 0x800) { > + printk(KERN_INFO "Found NAND on CS%d\n", cs); > + if (nandcs > GPMC_CS_NUM) > + nandcs = cs; > + } > + cs++; > + } Shouldn't this be some generic bit of code? > + > + if (nandcs > GPMC_CS_NUM) { > + printk(KERN_INFO "NAND: Unable to find configuration " > + "in GPMC\n "); > + return; > + } > + > + if (nandcs < GPMC_CS_NUM) { > + omap3pandora_nand_data.cs = nandcs; > + omap3pandora_nand_data.gpmc_cs_baseaddr = (void *) > + (gpmc_base_add + GPMC_CS0_BASE + nandcs * GPMC_CS_SIZE); > + omap3pandora_nand_data.gpmc_baseaddr = (void *) (gpmc_base_add); Unnecessary casts with proper typing of gpmc_base_add. > + > + printk(KERN_INFO "Registering NAND on CS%d\n", nandcs); Shouldn't something also update omap3pandora_nand_resource? > + if (platform_device_register(&omap3pandora_nand_device) < 0) > + printk(KERN_ERR "Unable to register NAND device\n"); > + } > +} > + > +static struct omap_uart_config omap3pandora_uart_config __initdata = { > + .enabled_uarts = (1 << 2), /* UART3 */ > +}; > + > +static struct twl4030_gpio_platform_data omap3pandora_gpio_data = { > + .gpio_base = OMAP_MAX_GPIO_LINES, > + .irq_base = TWL4030_GPIO_IRQ_BASE, > + .irq_end = TWL4030_GPIO_IRQ_END, > +}; > + > +static struct twl4030_usb_data omap3pandora_usb_data = { > + .usb_mode = T2_USB_MODE_ULPI, > +}; > + > +static struct twl4030_platform_data omap3pandora_twldata = { > + .irq_base = TWL4030_IRQ_BASE, > + .irq_end = TWL4030_IRQ_END, > + .gpio = &omap3pandora_gpio_data, > + .usb = &omap3pandora_usb_data, > +}; > + > +static struct i2c_board_info __initdata omap3pandora_i2c_boardinfo[] = { > + { > + I2C_BOARD_INFO("tps65950", 0x48), > + .flags = I2C_CLIENT_WAKE, > + .irq = INT_34XX_SYS_NIRQ, > + .platform_data = &omap3pandora_twldata, > + }, > +}; > + > +static int __init omap3pandora_i2c_init(void) > +{ > + omap_register_i2c_bus(1, 2600, omap3pandora_i2c_boardinfo, > + ARRAY_SIZE(omap3pandora_i2c_boardinfo)); > + /* i2c2 pins are not connected */ > + omap_register_i2c_bus(3, 400, NULL, 0); > + return 0; > +} > + > +static void __init omap3pandora_init_irq(void) > +{ > + omap2_init_common_hw(); > + omap_init_irq(); > + omap_gpio_init(); > +} > + > +static void __init omap3pandora_ads7846_init(void) > +{ > + int gpio = OMAP3_PANDORA_TS_GPIO; > + int ret; > + > + ret = gpio_request(gpio, "ads7846_pen_down"); > + if (ret < 0) { > + printk(KERN_ERR "Failed to request GPIO %d for " > + "ads7846 pen down IRQ\n", gpio); > + return; > + } > + > + gpio_direction_input(gpio); > +} > + > +static int ads7846_get_pendown_state(void) > +{ > + return !gpio_get_value(OMAP3_PANDORA_TS_GPIO); > +} > + > +static struct ads7846_platform_data ads7846_config = { > + .x_max = 0x0fff, > + .y_max = 0x0fff, > + .x_plate_ohms = 180, > + .pressure_max = 255, > + .debounce_max = 10, > + .debounce_tol = 3, > + .debounce_rep = 1, > + .get_pendown_state = ads7846_get_pendown_state, > + .keep_vref_on = 1, > +}; > + > +static struct omap2_mcspi_device_config ads7846_mcspi_config = { > + .turbo_mode = 0, > + .single_channel = 1, /* 0: slave, 1: master */ > +}; > + > +static struct spi_board_info omap3pandora_spi_board_info[] __initdata = { > + { > + .modalias = "ads7846", > + .bus_num = 1, > + .chip_select = 0, > + .max_speed_hz = 1500000, > + .controller_data = &ads7846_mcspi_config, > + .irq = OMAP_GPIO_IRQ(OMAP3_PANDORA_TS_GPIO), > + .platform_data = &ads7846_config, > + } > +}; > + > +static struct platform_device omap3pandora_lcd_device = { > + .name = "pandora_lcd", > + .id = -1, > +}; > + > +static struct omap_lcd_config omap3pandora_lcd_config __initdata = { > + .ctrl_name = "internal", > +}; > + > +static struct omap_board_config_kernel omap3pandora_config[] __initdata = { > + { OMAP_TAG_UART, &omap3pandora_uart_config }, > + { OMAP_TAG_LCD, &omap3pandora_lcd_config }, > +}; > + > +static struct platform_device *omap3pandora_devices[] __initdata = { > + &omap3pandora_lcd_device, > +}; > + > +static void __init omap3pandora_init(void) > +{ > + omap3pandora_i2c_init(); > + platform_add_devices(omap3pandora_devices, > + ARRAY_SIZE(omap3pandora_devices)); > + omap_board_config = omap3pandora_config; > + omap_board_config_size = ARRAY_SIZE(omap3pandora_config); > + omap_serial_init(); > + spi_register_board_info(omap3pandora_spi_board_info, > + ARRAY_SIZE(omap3pandora_spi_board_info)); > + omap3pandora_flash_init(); > + omap3pandora_ads7846_init(); > +} > + > +static void __init omap3pandora_map_io(void) > +{ > + omap2_set_globals_343x(); > + omap2_map_common_io(); > +} > + > +MACHINE_START(OMAP3_PANDORA, "Pandora Handheld Console") > + .phys_io = 0x48000000, > + .io_pg_offst = ((0xd8000000) >> 18) & 0xfffc, > + .boot_params = 0x80000100, > + .map_io = omap3pandora_map_io, > + .init_irq = omap3pandora_init_irq, > + .init_machine = omap3pandora_init, > + .timer = &omap_timer, > +MACHINE_END > > > ------------------------------------------------------------------- > List admin: http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm-kernel > FAQ: http://www.arm.linux.org.uk/mailinglists/faq.php > Etiquette: http://www.arm.linux.org.uk/mailinglists/etiquette.php -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html