Re: EMM386 not installed - protected mode software already running.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]


On Tue, 2010-10-19 at 09:28 -0500, Steve Cohen wrote:
> Is there a way to achieve the same results as the command
> DEVICE=C:\DOS\EMM386.EXE frame=none x=C000-C7FF x=E000-E7FF
> through dosemu.conf entries without loading the EMM386 driver?  I
> don't 
> know why these particular switches are necessary, but the previous 
> system is my starting point here.

emm.sys comes with dosemu.  the x= parts of your command are just
excluding certain memory areas from being managed by the emm driver.
Depending on why those areas are being excluded, it may not be necessary
to do that in your dosemu install.

Try loading emm.sys instead of emm386.exe and see if anything
interesting happens.
MELVILLE THEATRE ~ Melville Sask ~

To unsubscribe from this list: send the line "unsubscribe linux-msdos" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at

[Index of Archives]     [Linux Console]     [Linux Audio]     [Linux for Hams]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite Camping]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]     [Samba]     [Linux Media]     [Fedora Users]

  Powered by Linux