The trick was with bad reception indoors. I went testing to the balcony and framedrop dissapeared, and I get a clear picture. It seems that the Antenna is too weak in my apartment to have a clear signal. Kind regards, Jan On Sat, Apr 14, 2012 at 4:43 PM, Jan Prunk <janprunk@xxxxxxxxx> wrote: > Hello Oliver, > > Thank you for your hint. > > I have written up a WIKI page for this device, which hasn't been > written earlier. > I am willing to test the device further, if any of the devs can give > me further hints > for that. It's still not in a full working mode. I mean video is > somehow partially visible > with VLC, but I am no expert in fine-tuning the device. > > The wiki page is located at > http://linuxtv.org/wiki/index.php/ASUS_My_Cinema-U3100_Mini > > I will update the information there, if I will receive any further hints. > > Kind regards, > Jan > > On Tue, Apr 10, 2012 at 11:32 AM, Oliver Schinagl > <oliver+list@xxxxxxxxxxx> wrote: >> Unfortunatly I am not familiar with the dib0700 device, so not sure if you >> need firmware (I assume so, check linuxtv wiki on any dib0700 device. >> >> To test the device in its most basic level, I think w_scan is the best bet, >> as it works without any other extra files. >> >> Oliver >> >> >> On 07-04-12 23:32Hello , Jan Prunk wrote: >>> >>> Hi Oliver ! >>> >>> Thank you for your quick response. >>> >>> I assume that mine is a non-plus version. >>> Do you know how I could proceed tuning the channel list, >>> which I could then use in the combination with MPlayer ? >>> >>> Kind regards, >>> Jan >>> >>> On Sat, Apr 7, 2012 at 10:15 PM, Oliver Schinagl<oliverlist@xxxxxxxxxxx> >>> wrote: >>>> >>>> Hi Jan, >>>> >>>> That page is probably not supported by linux-media and shows support >>>> (currently not working afaik) forthe U3100 mini PLUS. yes, minor >>>> difference >>>> in name, huge difference inside. The non-plus is a dib0700 based device, >>>> whereas the Plus is a af9035 based device. The non-plus should work out >>>> of >>>> the box on most distro's. >>>> >>>> Oliver >>>> >>>> >>>> On 07-04-12 20:21, Jan Prunk wrote: >>>>> >>>>> Hi ! >>>>> >>>>> I have ASUS U3100 Mini USB Dongle and I would like to watch DVB-T >>>>> TV streams with it on Debian. The dongle when its plugged in lights with >>>>> the green light. Performing "(dvb)scan" segfaults. >>>>> >>>>> I (partially) followed these guides: >>>>> >>>>> http://linuxtv.org/wiki/index.php/Asus_U3100_Mini_plus_DVB-T >>>>> >>>>> I am using debian testing and it seems the device gets somehow >>>>> recognised: >>>>> >>>>> [15120.976095] usb 3-1: USB disconnect, device number 2 >>>>> [15124.716041] usb 1-3: new high-speed USB device number 5 using >>>>> ehci_hcd >>>>> [15124.848958] usb 1-3: New USB device found, idVendor=0b05, >>>>> idProduct=173f >>>>> [15124.848964] usb 1-3: New USB device strings: Mfr=1, Product=2, >>>>> SerialNumber=3 >>>>> [15124.848970] usb 1-3: Product: ASUS DVBT Tuner >>>>> [15124.848974] usb 1-3: Manufacturer: ASUSTeK >>>>> [15124.848977] usb 1-3: SerialNumber: 8500500875 >>>>> [15125.344564] IR NEC protocol handler initialized >>>>> [15125.370992] IR RC5(x) protocol handler initialized >>>>> [15125.409376] dib0700: loaded with support for 21 different >>>>> device-types >>>>> [15125.409588] dvb-usb: found a 'ASUS My Cinema U3100 Mini DVBT Tuner' >>>>> in cold state, will try to load a firmware >>>>> [15125.412893] IR RC6 protocol handler initialized >>>>> [15125.440888] IR JVC protocol handler initialized >>>>> [15125.463698] dvb-usb: downloading firmware from file >>>>> 'dvb-usb-dib0700-1.20.fw' >>>>> [15125.465236] IR Sony protocol handler initialized >>>>> [15125.468745] IR MCE Keyboard/mouse protocol handler initialized >>>>> [15125.473597] lirc_dev: IR Remote Control driver registered, major 249 >>>>> [15125.474883] IR LIRC bridge handler initialized >>>>> [15125.671203] dib0700: firmware started successfully. >>>>> [15126.172240] dvb-usb: found a 'ASUS My Cinema U3100 Mini DVBT Tuner' >>>>> in warm state. >>>>> [15126.172346] dvb-usb: will pass the complete MPEG2 transport stream >>>>> to the software demuxer. >>>>> [15126.172902] DVB: registering new adapter (ASUS My Cinema U3100 Mini >>>>> DVBT Tuner) >>>>> [15126.390206] DVB: registering adapter 0 frontend 0 (DiBcom 7000PC)... >>>>> [15126.607078] DiB0070: successfully identified >>>>> [15126.708031] Registered IR keymap rc-dib0700-rc5 >>>>> [15126.708271] input: IR-receiver inside an USB DVB receiver as >>>>> /devices/pci0000:00/0000:00:1d.7/usb1/1-3/rc/rc0/input12 >>>>> [15126.709054] rc0: IR-receiver inside an USB DVB receiver as >>>>> /devices/pci0000:00/0000:00:1d.7/usb1/1-3/rc/rc0 >>>>> [15126.710265] dvb-usb: schedule remote query interval to 50 msecs. >>>>> [15126.710273] dvb-usb: ASUS My Cinema U3100 Mini DVBT Tuner >>>>> successfully initialized and connected. >>>>> [15126.710492] usbcore: registered new interface driver dvb_usb_dib0700 >>>>> [15557.359129] scan[3798]: segfault at 3 ip b7620aa6 sp bfc268ac error >>>>> 4 in libc-2.13.so[b75e2000+156000] >>>>> [15650.161033] scan[3836]: segfault at 3 ip b766faa6 sp bf9974dc error >>>>> 4 in libc-2.13.so[b7631000+156000] >>>>> >>>>> After this I used the guide at: >>>>> http://www.linuxtv.org/wiki/index.php/Testing_your_DVB_device >>>>> >>>>> Which resulted into: >>>>> yang@vaio:~$ scan /usr/share/dvb/dvb-t/si-Ljubljana> >>>>> ~/.tzap/channels.conf >>>>> scanning /usr/share/dvb/dvb-t/si-Ljubljana >>>>> using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' >>>>> initial transponder 602000000 0 2 9 3 1 3 0 >>>>> initial transponder 514000000 0 2 9 3 1 2 0 >>>>>>>> >>>>>>>> tune to: >>>>>>>> >>>>>>>> 602000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE >>>>> >>>>> WARNING:>>> tuning failed!!! >>>>>>>> >>>>>>>> tune to: >>>>>>>> >>>>>>>> 602000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE >>>>>>>> (tuning failed) >>>>> >>>>> WARNING:>>> tuning failed!!! >>>>>>>> >>>>>>>> tune to: >>>>>>>> >>>>>>>> 514000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_8:HIERARCHY_NONE >>>>> >>>>> WARNING:>>> tuning failed!!! >>>>>>>> >>>>>>>> tune to: >>>>>>>> >>>>>>>> 514000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_8:HIERARCHY_NONE >>>>>>>> (tuning failed) >>>>> >>>>> WARNING:>>> tuning failed!!! >>>>> ERROR: initial tuning failed >>>>> dumping lists (0 services) >>>>> Done. >>>>> >>>>> So I seem to be stuck here. >>>>> >>>>> I please for some guidance here, thank you ! >>>>> >>>>> Kind regards, >>>>> Jan Prunk >>>> >>>> >>> >>> >> > > > > -- > Jan Prunk http://www.prunk.si > 0x00E80E86 http://pgp.prunk.si > http://AS50763.peeringdb.com -- Jan Prunk http://www.prunk.si 0x00E80E86 http://pgp.prunk.si http://AS50763.peeringdb.com -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
