Hi Mauro,
On 18-08-01 12:50, Mauro Carvalho Chehab wrote:
> Em Wed, 1 Aug 2018 16:49:26 +0200
> Marco Felsch <m.felsch@xxxxxxxxxxxxxx> escreveu:
>
> > Hi Mauro,
> >
> > On 18-08-01 11:22, Mauro Carvalho Chehab wrote:
> > > Em Wed, 1 Aug 2018 15:21:25 +0200
> > > Marco Felsch <m.felsch@xxxxxxxxxxxxxx> escreveu:
> > >
> > > > Hi Mauro,
> > > >
> > > > On 18-07-30 15:09, Mauro Carvalho Chehab wrote:
> > > > > Em Thu, 28 Jun 2018 18:20:48 +0200
> > > > > Marco Felsch <m.felsch@xxxxxxxxxxxxxx> escreveu:
> > > > >
> > > > > > From: Philipp Zabel <p.zabel@xxxxxxxxxxxxxx>
> > > > > >
> > > > > > Add the querystd video_op and make it return V4L2_STD_UNKNOWN while the
> > > > > > TVP5150 is not locked to a signal.
> > > > > >
> > > > > > Signed-off-by: Philipp Zabel <p.zabel@xxxxxxxxxxxxxx>
> > > > > > Signed-off-by: Marco Felsch <m.felsch@xxxxxxxxxxxxxx>
> > > > > > ---
> > > > > > drivers/media/i2c/tvp5150.c | 10 ++++++++++
> > > > > > 1 file changed, 10 insertions(+)
> > > > > >
> > > > > > diff --git a/drivers/media/i2c/tvp5150.c b/drivers/media/i2c/tvp5150.c
> > > > > > index 99d887936ea0..1990aaa17749 100644
> > > > > > --- a/drivers/media/i2c/tvp5150.c
> > > > > > +++ b/drivers/media/i2c/tvp5150.c
> > > > > > @@ -796,6 +796,15 @@ static v4l2_std_id tvp5150_read_std(struct v4l2_subdev *sd)
> > > > > > }
> > > > > > }
> > > > > >
> > > > > > +static int tvp5150_querystd(struct v4l2_subdev *sd, v4l2_std_id *std_id)
> > > > > > +{
> > > > > > + struct tvp5150 *decoder = to_tvp5150(sd);
> > > > > > +
> > > > > > + *std_id = decoder->lock ? tvp5150_read_std(sd) : V4L2_STD_UNKNOWN;
> > > > >
> > > > > This patch requires rework. What happens when a device doesn't have
> > > > > IRQ enabled? Perhaps it should, instead, read some register in order
> > > > > to check for the locking status, as this would work on both cases.
> > > >
> > > > If IRQ isn't enabled, decoder->lock is set to always true during
> > > > probe(). So this case should be fine.
> > >
> > > Not sure if tvp5150_read_std() will do the right thing. If it does,
> > > the above could simply be:
> > > std_id = tvp5150_read_std(sd);
> > >
> > > But, as there are 3 variants of this chipset, it sounds safer to check
> > > if the device is locked before calling tvp5150_read_std().
> >
> > Yes, I'm with you.
> >
> > >
> > > IMHO, the best would be to have a patch like the one below.
> > >
> > > Regards,
> > > Mauro
> > >
> > > [PATCH] media: tvp5150: implement decoder lock when irq is not used
> > >
> > > When irq is used, the lock is set via IRQ code. When it isn't,
> > > the driver just assumes it is always locked. Instead, read the
> > > lock status from the status register.
> >
> > Yes, that is a better solution.
> >
> > >
> > > Compile-tested only.
> > >
> > > Signed-off-by: Mauro Carvalho Chehab <mchehab+samsung@xxxxxxxxxx>
> > >
> > > diff --git a/drivers/media/i2c/tvp5150.c b/drivers/media/i2c/tvp5150.c
> > > index 75e5ffc6573d..e07020d4053d 100644
> > > --- a/drivers/media/i2c/tvp5150.c
> > > +++ b/drivers/media/i2c/tvp5150.c
> > > @@ -811,11 +811,24 @@ static v4l2_std_id tvp5150_read_std(struct v4l2_subdev *sd)
> > > }
> > > }
> > >
> > > +static int query_lock(struct v4l2_subdev *sd)
> > > +{
> > > + struct tvp5150 *decoder = to_tvp5150(sd);
> > > + int status;
> > > +
> > > + if (decoder->irq)
> > > + return decoder->lock;
> > > +
> > > + regmap_read(map, TVP5150_INT_STATUS_REG_A, &status);
> > > +
> > > + return (status & 0x06) == 0x06;
> >
> > Typo? It should be 0x80, as described in the datasheet (SLES209E) or
> > just use the TVP5150_INT_A_LOCK_STATUS define. This avoid datasheet
> > cross check during reading.
>
> Yes, it is a typo, but at the other line... I meant to use the register
> 0x88, e. g.:
>
> regmap_read(decoder->regmap, TVP5150_STATUS_REG_1, &status);
During my development I tried this status register too, as descibed on
the community website [1]. But that wasn't that good, because the look
will be lost very often. Bit7 of Interrupt Status Reg A (0xc0) is more
robust for that kind of work, since it covers the whole signal.
[1] http://e2e.ti.com/support/data_converters/videoconverters/f/918/p/ \
617120/2273276?keyMatch=tvp5150%20lock%20lost&tisearch=Search-EN-Support
>
> I ran some tests here: the int status reg is not updated.
>
> Also, after thinking a little bit, I opted to not use the query_lock()
> at s_stream. It makes no sense there without adding a status polling
> logic. I also opted to remove initializing decoder->lock to true, as
> this is very counter-intuitive. Instead, I'm adding a test at s_stream
> if decoder->irq is set. This makes easier to understand the code.
Yes, you're right.
> Btw, on my tests here, I noticed a problem with S-Video... at least with
> AV-350 grabber, composite is only working when S-Video is connected.
Unfortunately I have only a custom board with one composite connection.
>
> This bug also happens before your patchset, so this is not a regression
> caused by your patches.
>
> Anyway, patch enclosed. I added it together with my patch series at:
>
> https://git.linuxtv.org/mchehab/experimental.git/log/?h=tvp5150-2
Did you drop the DT of_graph support patch? It was there on your first
tvp5150 branch.
>
> I'll keep doing more tests here.
>
> >
> > > +}
> > > +
> > > static int tvp5150_querystd(struct v4l2_subdev *sd, v4l2_std_id *std_id)
> > > {
> > > struct tvp5150 *decoder = to_tvp5150(sd);
> > >
> > > - *std_id = decoder->lock ? tvp5150_read_std(sd) : V4L2_STD_UNKNOWN;
> > > + *std_id = query_lock(sd) ? tvp5150_read_std(sd) : V4L2_STD_UNKNOWN;
> > >
> > > return 0;
> > > }
> > > @@ -1247,7 +1260,7 @@ static int tvp5150_s_stream(struct v4l2_subdev *sd, int enable)
> > > tvp5150_enable(sd);
> > >
> > > /* Enable outputs if decoder is locked */
> > > - val = decoder->lock ? decoder->oe : 0;
> > > + val = query_lock(sd) ? decoder->oe : 0;
> > > int_val = TVP5150_INT_A_LOCK;
> > > v4l2_subdev_notify_event(&decoder->sd, &tvp5150_ev_fmt);
> > > }
> > > @@ -1816,8 +1829,6 @@ static int tvp5150_probe(struct i2c_client *c,
> > > IRQF_ONESHOT, "tvp5150", core);
> > > if (res)
> > > return res;
> > > - } else {
> > > - core->lock = true;
> > > }
> > >
> > > res = v4l2_async_register_subdev(sd);
> > >
> > >
> > >
>
> [PATCH] media: tvp5150: implement decoder lock when irq is not used
>
> When irq is used, the lock is set via IRQ code. When it isn't,
> the driver just assumes it is always locked. Instead, read the
> lock status from the status register.
>
> Signed-off-by: Mauro Carvalho Chehab <mchehab+samsung@xxxxxxxxxx>
>
> diff --git a/drivers/media/i2c/tvp5150.c b/drivers/media/i2c/tvp5150.c
> index efc441df7cac..e74af68be2eb 100644
> --- a/drivers/media/i2c/tvp5150.c
> +++ b/drivers/media/i2c/tvp5150.c
> @@ -810,11 +810,25 @@ static v4l2_std_id tvp5150_read_std(struct v4l2_subdev *sd)
> }
> }
>
> +static int query_lock(struct v4l2_subdev *sd)
> +{
> + struct tvp5150 *decoder = to_tvp5150(sd);
> + int status;
> +
> + if (decoder->irq)
> + return decoder->lock;
> +
> + regmap_read(decoder->regmap, TVP5150_STATUS_REG_1, &status);
> +
> + /* For standard detection, we need the 3 locks */
> + return (status & 0x0e) == 0x0e;
> +}
> +
> static int tvp5150_querystd(struct v4l2_subdev *sd, v4l2_std_id *std_id)
> {
> struct tvp5150 *decoder = to_tvp5150(sd);
We should drop the decoder var here and not in the cleanup patch "media:
tvp5150: get rid of some warnings". There are always two version of the
patch that remove the 'static' warning [2,3].
[2] https://www.spinics.net/lists/linux-media/msg138318.html
[3] https://www.spinics.net/lists/linux-media/msg138363.html
Regards,
Marco
>
> - *std_id = decoder->lock ? tvp5150_read_std(sd) : V4L2_STD_UNKNOWN;
> + *std_id = query_lock(sd) ? tvp5150_read_std(sd) : V4L2_STD_UNKNOWN;
>
> return 0;
> }
> @@ -1208,7 +1222,10 @@ static int tvp5150_s_stream(struct v4l2_subdev *sd, int enable)
> tvp5150_enable(sd);
>
> /* Enable outputs if decoder is locked */
> - val = decoder->lock ? decoder->oe : 0;
> + if (decoder->irq)
> + val = decoder->lock ? decoder->oe : 0;
> + else
> + val = decoder->oe;
> int_val = TVP5150_INT_A_LOCK;
> v4l2_subdev_notify_event(&decoder->sd, &tvp5150_ev_fmt);
> }
> @@ -1777,8 +1794,6 @@ static int tvp5150_probe(struct i2c_client *c,
> IRQF_ONESHOT, "tvp5150", core);
> if (res)
> return res;
> - } else {
> - core->lock = true;
> }
>
> res = v4l2_async_register_subdev(sd);
>
>
>
> Thanks,
> Mauro
>
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
