On Fri, May 25, 2018 at 04:42:02PM +0200, Michał Winiarski wrote: > On Fri, May 25, 2018 at 02:59:41PM +0100, Sean Young wrote: > > On Fri, May 25, 2018 at 03:35:23PM +0200, Michał Winiarski wrote: > > > On Thu, May 24, 2018 at 12:31:40PM +0100, Sean Young wrote: > > > > On Mon, May 21, 2018 at 04:38:03PM +0200, Michał Winiarski wrote: > > > > > Doing writes when the device is disabled seems to be a NOOP. > > > > > Let's enable the device, write the values, and then disable it on init. > > > > > This changes the behavior for wake device, which is now being disabled > > > > > after init. > > > > > > > > I don't have the datasheet so I might be misunderstanding this. We want > > > > the IR wakeup to work fine even after kernel crash/power loss, right? > > > > > > [snip] > > > > > > Right, that makes sense. I completely ignored this scenario. > > > > > > > > - /* enable the CIR WAKE logical device */ > > > > > - nvt_enable_logical_dev(nvt, LOGICAL_DEV_CIR_WAKE); > > > > > + nvt_disable_logical_dev(nvt, LOGICAL_DEV_CIR); > > > > > > > > The way I read this is that the CIR, not CIR_WAKE, is being disabled, > > > > which seems contrary to what the commit message says. > > > > > > > > > > That's a typo. And by accident it makes the wake_device work correctly :) > > > I think that registers init logic was still broken though, operating under the > > > assumption that the device is enabled on module load... > > > > > > I guess we should just remove disable(LOGICAL_DEV_CIR) from wake_regs_init. > > > > > > Have you already included this in any non-rebasing tree? > > > > Nothing has been applied yet. > > > > > Should I send a v2 or fixup on top? > > > > I don't have the hardware to test this, a v2 would be appreciated. > > > > We're late in the release cycle and I'm wondering if this patch would also > > solve the nuvoton probe problem: > > > > https://patchwork.linuxtv.org/patch/49874/ > > It causes us to go back to previous behavior (we're refcounting open/close, > with your patch initial open on my system is coming from kbd_connect(), so > userspace close() doesn't propagate to nuvoton-cir). > > It passes my test of "load the module with debug=1, see if I'm getting > interrupts". > > If there's any scenario in which->close() would be called, it's still going to > be broken. Great, thank you very much for testing that. I've created a pull request for the v2 version. Sean
