Devin Heitmueller ha scritto:
Hello all,
I have setup a tree that removes the mode switching code when
starting/stopping streaming. If you have one of the em28xx dvb
devices mentioned in the previous thread and volunteered to test,
please try out the following tree:
http://kernellabs.com/hg/~dheitmueller/em28xx-modeswitch
In particular, this should work for those of you who reported problems
with zl10353 based devices like the Pinnacle 320e (or Dazzle) and were
using that one line change I sent this week. It should also work with
Antti's Reddo board without needing his patch to move the demod reset
into the tuner_gpio.
This also brings us one more step forward to setting up the locking
properly so that applications cannot simultaneously open the analog
and dvb side of the device.
Thanks for your help,
Devin
Hi Devin,
excuse my late, but I've done some test.
The scanning now work correctly and without problem, all MUX was tuned
and channel recognized.
With mplayer no problem, for a new channel I must stop the actual
channel viewing and start a new one instance of mplayer.
I've a problem with kaffeine, and this problem before was not present
(I've not tested with the previous temporary patch).
To reproduce the problem, is necessary a channel change, and the two
channel must be on a different MUX: the first double click on new
channel name display an "Impossible to tune", if I do a new double click
the channel was opened. Is like the adapter was resetted, but not
reinitialized on new frequency.
Logically the problem not appears if I stop the transmission between the
channel change or if I change channel that are located on the same MUX.
I hope to have explained well the thing.
Thanks and bye,
Sebastian
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
