On Wed, Oct 14, 2009 at 6:25 AM, Giuseppe Borzi <gborzi@xxxxxxxxx> wrote: >> Hello all, >> >> I have setup a tree that removes the mode switching code when >> starting/stopping streaming. If you have one of the em28xx dvb >> devices mentioned in the previous thread and volunteered to test, >> please try out the following tree: >> >> http://kernellabs.com/hg/~dheitmueller/em28xx-modeswitch >> >> In particular, this should work for those of you who reported problems >> with zl10353 based devices like the Pinnacle 320e (or Dazzle) and were >> using that one line change I sent this week. It should also work with >> Antti's Reddo board without needing his patch to move the demod reset >> into the tuner_gpio. >> >> This also brings us one more step forward to setting up the locking >> properly so that applications cannot simultaneously open the analog >> and dvb side of the device. >> >> Thanks for your help, >> >> Devin >> > Hello Devin, > I've just downloaded, compiled and installed em28xx-modeswitch. > Unfortunately, it doesn't work and doesn't even > create /dev/dvb, /dev/videoX, /dev/vbiX. Only /dev/dsp1 is created. > The dmesg is attached to this email. As you can see it ends up in > errors. > One last note, I downloaded from the bz2 link. > > Cheers. Did you run "make unload" before you plugged in the device? Do me a favor - unplug the device, reboot the PC, plug it back in and see if it still happens. I just want to be sure this isn't some sort of issue with conflict between the new and old modules before I debug this any further. Thanks, Devin -- Devin J. Heitmueller - Kernel Labs http://www.kernellabs.com -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
