On Fri 2016-11-04 00:20:14, Sakari Ailus wrote: > Hi Pavel and Rob, > > On Thu, Nov 03, 2016 at 01:47:49PM +0100, Pavel Machek wrote: > > Hi! > > > > > > +Mandatory properties > > > > +-------------------- > > > > + > > > > +- compatible: "toshiba,et8ek8" > > > > +- reg: I2C address (0x3e, or an alternative address) > > > > +- vana-supply: Analogue voltage supply (VANA), 2.8 volts > > > > +- clocks: External clock to the sensor > > > > +- clock-frequency: Frequency of the external clock to the sensor. Camera > > > > + driver will set this frequency on the external clock. > > > > > > This is fine if the frequency is fixed (e.g. an oscillator), but you > > > should use the clock binding if clocks are programable. > > > > It is fixed. So I assume this can stay as is? Or do you want me to add > > "The clock frequency is a pre-determined frequency known to be > > suitable to the board." as Sakari suggests? Rob? Pavel > > > > +- reset-gpios: XSHUTDOWN GPIO > > > > > > Please state what the active polarity is. > > > > As in "This gpio will be set to 1 when the chip is powered." ? > > How about: > > "The XSHUTDOWN signal is active high. The sensor is in hardware standby > mode when the signal is in low state." > > These bindings start looking more precise than the smiapp ones. :-) > -- (english) http://www.livejournal.com/~pavelmachek (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
Attachment:
signature.asc
Description: Digital signature
