Hi Pavel and Rob, On Thu, Nov 03, 2016 at 01:47:49PM +0100, Pavel Machek wrote: > Hi! > > > > +Mandatory properties > > > +-------------------- > > > + > > > +- compatible: "toshiba,et8ek8" > > > +- reg: I2C address (0x3e, or an alternative address) > > > +- vana-supply: Analogue voltage supply (VANA), 2.8 volts > > > +- clocks: External clock to the sensor > > > +- clock-frequency: Frequency of the external clock to the sensor. Camera > > > + driver will set this frequency on the external clock. > > > > This is fine if the frequency is fixed (e.g. an oscillator), but you > > should use the clock binding if clocks are programable. > > It is fixed. So I assume this can stay as is? Or do you want me to add > "The clock frequency is a pre-determined frequency known to be > suitable to the board." as Sakari suggests? > > > > +- reset-gpios: XSHUTDOWN GPIO > > > > Please state what the active polarity is. > > As in "This gpio will be set to 1 when the chip is powered." ? How about: "The XSHUTDOWN signal is active high. The sensor is in hardware standby mode when the signal is in low state." These bindings start looking more precise than the smiapp ones. :-) -- Sakari Ailus e-mail: sakari.ailus@xxxxxx XMPP: sailus@xxxxxxxxxxxxxx -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
