George Czerw wrote:
On Tuesday 30 June 2009 13:43:49 you wrote:
On Tue, Jun 30, 2009 at 1:01 PM, George Czerw<gczerw@xxxxxxxxxxx> wrote:
Using Mandriva 2009.1 with HVR connected directly to analog cable.
Using 32-bit kernel 2.6.29.3-desktop-1.mnb.
TVtime and xawTV both open but display only snow. Channel scanning
yields nothing.
If I boot into Vista and load MediaCenter, open liveTV and watch a
channel. Then close MediaCenter, exit Vista and boot into linux, TVtime
and xawTV (if I am lucky) might open-up and perfectly display the TV
channel that I was last viewing in Vista, but will not change channels to
another station no matter what I do.
Please see the following outputs below. I would appreciate any
suggestions to resolve this. Not having hardware problems since
WinVista's media center works perfectly with this hardware.
Thanks
George
*************************
tvtime -v
Running tvtime 1.0.2.
Reading configuration from /etc/tvtime/tvtime.xml
Reading configuration from /home/george/.tvtime/tvtime.xml
cpuinfo: CPU Intel(R) Core(TM)2 Quad CPU Q8200 @ 2.33GHz, family 6,
model 7, stepping 7.
cpuinfo: CPU measured at 2333.352MHz.
xcommon: Display :0.0, vendor The X.Org Foundation, vendor release
10601000
xfullscreen: Using XINERAMA for dual-head information.
xfullscreen: Pixels are square.
xfullscreen: Number of displays is 1.
xfullscreen: Head 0 at 0,0 with size 1440x900.
xcommon: Have XTest, will use it to ping the screensaver.
xcommon: Pixel aspect ratio 1:1.
xcommon: Pixel aspect ratio 1:1.
xcommon: Window manager is KWin and is EWMH compliant.
xcommon: Using EWMH state fullscreen property.
xcommon: Using EWMH state above property.
xcommon: Using EWMH state below property.
xcommon: Pixel aspect ratio 1:1.
xcommon: Displaying in a 768x576 window inside 768x576 space.
xvoutput: Using XVIDEO adaptor 280: NV17 Video Texture.
speedycode: Using MMXEXT optimized functions.
station: Reading stationlist from /home/george/.tvtime/stationlist.xml
videoinput: Using video4linux2 driver 'cx23885', card 'Hauppauge
WinTV-HVR1800' (bus PCIe:0000:03:00.0).
videoinput: Version is 1, capabilities 5010011.
videoinput: Maximum input width: 720 pixels.
tvtime: Sampling input at 720 pixels per scanline.
xcommon: Pixel aspect ratio 1:1.
xcommon: Displaying in a 768x576 window inside 768x576 space.
xcommon: Received a map, marking window as visible (62).
xcommon: Window fully obscured, marking window as hidden (62).
xcommon: Window made visible, marking window as visible (62).
tvtime: Cleaning up.
Thank you for using tvtime.
********************
# lspci
00:00.0 Host bridge: Intel Corporation 82G33/G31/P35/P31 Express DRAM
Controller (rev
02)
00:01.0 PCI bridge: Intel Corporation 82G33/G31/P35/P31 Express PCI
Express Root Port (rev
02)
00:1a.0 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI
Controller #4 (rev
02)
00:1a.1 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI
Controller #5 (rev
02)
00:1a.7 USB Controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI
Controller #2 (rev
02)
00:1b.0 Audio device: Intel Corporation 82801I (ICH9 Family) HD Audio
Controller (rev
02)
00:1c.0 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express
Port 1 (rev 02)
00:1c.1 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express
Port 2 (rev 02)
00:1c.2 PCI bridge: Intel Corporation 82801I (ICH9 Family) PCI Express
Port 3 (rev 02)
00:1d.0 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI
Controller #1 (rev 02)
00:1d.1 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI
Controller #2 (rev 02)
00:1d.2 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI
Controller #3 (rev 02)
00:1d.3 USB Controller: Intel Corporation 82801I (ICH9 Family) USB UHCI
Controller #6 (rev 02)
00:1d.7 USB Controller: Intel Corporation 82801I (ICH9 Family) USB2 EHCI
Controller #1 (rev 02)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev 92) 00:1f.0
ISA bridge: Intel Corporation 82801IR (ICH9R) LPC Interface Controller
(rev 02)
00:1f.2 RAID bus controller: Intel Corporation 82801 SATA RAID Controller
(rev 02)
00:1f.3 SMBus: Intel Corporation 82801I (ICH9 Family) SMBus Controller
(rev 02)
01:05.0 FireWire (IEEE 1394): Agere Systems FW323 (rev 70) 02:00.0
Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI
Express Gigabit Ethernet controller (rev 02) 03:00.0 Multimedia video
controller: Conexant Systems, Inc. Device 8880 (rev 0f)
04:00.0 Network controller: Atheros Communications Inc. AR928X Wireless
Network Adapter (PCI-Express) (rev 01) 05:00.0 VGA compatible controller:
nVidia Corporation Device 0644 (rev a1)
*******************
# v4l-conf
v4l-conf: using X11 display :0.0
dga: version 2.0
WARNING: No DGA direct video mode for this display. mode: 1440x900,
depth=24, bpp=32, bpl=5760, base=unknown /dev/video0 [v4l2]: no overlay
support
*******************
selected DMESG output:
nvidia: module license 'NVIDIA' taints kernel.
nvidia 0000:05:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
nvidia 0000:05:00.0: setting latency timer to 64
Linux video capture interface: v2.00
cx23885 driver version 0.0.1 loaded
cx23885 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
CORE cx23885[0]: subsystem: 0070:7801, board: Hauppauge WinTV-HVR1800
[card=2,autodetected]
tveeprom 0-0050: Hauppauge model 78521, rev C1E9, serial# 5342357
tveeprom 0-0050: MAC address is 00-0D-FE-51-84-95
tveeprom 0-0050: tuner model is Philips 18271_8295 (idx 149, type 54)
tveeprom 0-0050: TV standards NTSC(M) ATSC/DVB Digital (eeprom 0x88)
tveeprom 0-0050: audio processor is CX23887 (idx 42)
tveeprom 0-0050: decoder processor is CX23887 (idx 37)
tveeprom 0-0050: has radio
cx23885[0]: hauppauge eeprom: model=78521
cx25840' 2-0044: cx25 0-21 found @ 0x88 (cx23885[0])
cx23885[0]/0: registered device video0 [v4l2]
cx25840' 2-0044: firmware: requesting v4l-cx23885-avcore-01.fw
cx25840' 2-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes)
cx23885[0]: registered device video1 [mpeg]
cx23885_dvb_register() allocating 1 frontend(s)
cx23885[0]: cx23885 based dvb card
MT2131: successfully identified at address 0x61
DVB: registering new adapter (cx23885[0])
DVB: registering adapter 0 frontend 0 (Samsung S5H1409 QAM/8VSB
Frontend)...
cx23885_dev_checkrevision() Hardware revision = 0xb1
cx23885[0]/0: found at 0000:03:00.0, rev: 15, irq: 17, latency: 0, mmio:
0xf9c00000
cx23885 0000:03:00.0: setting latency timer to 64
IRQ 17/cx23885[0]: IRQF_DISABLED is not guaranteed on shared IRQs
NVRM: loading NVIDIA UNIX x86 Kernel Module 180.51 Thu Apr 16 19:02:15
PDT 2009
Make sure that the 'tuner' module and the 'cx25840' modules are both
loaded.
Make sure that you're using the lower spigot (if you have 2 spigots)
or the middle spigot (if you have 3 spigots)
BTW, your email is off-topic for the linux-dvb mailing list. I added
cc to the linux-media mailing list, which is more appropriate for your
analog television problem.
Regards,
Mike
Mike, thanks for the reply. Two questions...
1. What do you mean by "spigots"?
2. By the tuner module, do you mean the cx23885??
Output of lsmod shows that cx25840, cx23885 & cx2341x are loaded
cx25840 27856 0
cx23885 85552 0
cx2341x 12800 1 cx23885
videobuf_dma_sg 12160 1 cx23885
videobuf_dvb 6848 1 cx23885
dvb_core 86112 1 videobuf_dvb
videobuf_core 17888 3 cx23885,videobuf_dma_sg,videobuf_dvb
v4l2_common 16220 3 cx25840,cx23885,cx2341x
videodev 40320 3 cx25840,cx23885,v4l2_common
v4l1_compat 13440 1 videodev
btcx_risc 4772 1 cx23885
tveeprom 11872 1 cx23885
Please, never remove cc from the public mailinglist. (cc re-added)
When I said 'tuner' module, I meant 'tuner' module :-P
Hope this helps,
Mike
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
