Hi Everyone, I'm having trouble with getting the Compro Video T750F to work under Ubuntu 8.10. I had the Compro T300 working great but this card is still eluding me. Any suggestions on how to proceed from here? The dmesg is posted below. Thanks, Andrew [ 13.317113] saa7130/34: v4l2 driver version 0.2.14 loaded [ 13.317703] ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16 [ 13.317709] saa7134 0000:04:08.0: PCI INT A -> Link[APC1] -> GSI 16 (level, low) -> IRQ 16 [ 13.317716] saa7133[0]: found at 0000:04:08.0, rev: 209, irq: 16, latency: 32, mmio: 0xfdbfe000 [ 13.317723] saa7133[0]: subsystem: 185b:c900, board: Compro VideoMate T750 [card=139,autodetected] [ 13.317734] saa7133[0]: board init: gpio is 84bf00 [ 13.317746] saa7133[0]: Oops: IR config error [card=139] [ 13.476035] saa7133[0]: i2c eeprom 00: 5b 18 00 c9 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 [ 13.476046] saa7133[0]: i2c eeprom 10: 00 ff 86 0f ff 20 ff ff ff ff ff ff ff ff ff ff [ 13.476055] saa7133[0]: i2c eeprom 20: 01 40 01 02 02 01 03 01 08 ff 00 87 ff ff ff ff [ 13.476064] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476072] saa7133[0]: i2c eeprom 40: ff d7 00 c4 86 1e 05 ff 02 c2 ff 01 c6 ff 05 ff [ 13.476081] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff cb [ 13.476089] saa7133[0]: i2c eeprom 60: 35 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476098] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476106] saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476115] saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476123] saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476132] saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476140] saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476149] saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476157] saa7133[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.476166] saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 13.508082] tuner 2-0062: chip found @ 0xc4 (saa7133[0]) [ 13.548912] xc2028 2-0062: creating new instance [ 13.548916] xc2028 2-0062: type set to XCeive xc2028/xc3028 tuner [ 13.548926] firmware: requesting xc3028-v27.fw [ 13.999716] input: ImPS/2 Generic Wheel Mouse as /devices/platform/i8042/serio1/input/input5 [ 14.055433] xc2028 2-0062: Loading 80 firmware images from xc3028-v27.fw, type: xc2028 firmware, ver 2.7 [ 14.055534] xc2028 2-0062: Loading firmware for type=BASE F8MHZ MTS (7), id 0000000000000000. [ 14.055940] xc2028 2-0062: i2c output error: rc = -5 (should be 64) [ 14.055943] xc2028 2-0062: -5 returned from send [ 14.055947] xc2028 2-0062: Error -22 while loading base firmware [ 14.108032] xc2028 2-0062: Loading firmware for type=BASE F8MHZ MTS (7), id 0000000000000000. [ 14.108570] xc2028 2-0062: i2c output error: rc = -5 (should be 64) [ 14.108573] xc2028 2-0062: -5 returned from send [ 14.108576] xc2028 2-0062: Error -22 while loading base firmware [ 14.108589] xc2028 2-0062: Loading firmware for type=BASE F8MHZ MTS (7), id 0000000000000000. [ 14.109126] xc2028 2-0062: i2c output error: rc = -5 (should be 64) [ 14.109128] xc2028 2-0062: -5 returned from send [ 14.109131] xc2028 2-0062: Error -22 while loading base firmware [ 14.165021] xc2028 2-0062: Loading firmware for type=BASE F8MHZ MTS (7), id 0000000000000000. [ 14.165555] xc2028 2-0062: i2c output error: rc = -5 (should be 64) [ 14.165557] xc2028 2-0062: -5 returned from send [ 14.165560] xc2028 2-0062: Error -22 while loading base firmware [ 14.166394] xc2028 2-0062: Error on line 1124: -5 [ 14.173289] saa7133[0]: registered device video0 [v4l2] [ 14.173451] saa7133[0]: registered device vbi0 [ 14.173507] saa7133[0]: registered device radio0 [ 14.174059] ACPI: PCI Interrupt Link [AAZA] enabled at IRQ 23 [ 14.174064] HDA Intel 0000:00:10.1: PCI INT B -> Link[AAZA] -> GSI 23 (level, low) -> IRQ 23 [ 14.174089] HDA Intel 0000:00:10.1: setting latency timer to 64 [ 14.196322] saa7134 ALSA driver for DMA sound loaded [ 14.196353] saa7133[0]/alsa: saa7133[0] at 0xfdbfe000 irq 16 registered as card -2 [ 14.337099] dvb_init() allocating 1 frontend [ 14.337105] saa7133[0]/dvb: Huh? unknown DVB card? [ 14.337108] saa7133[0]/dvb: frontend initialization failed -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
