There are multiple cases in the probe function that dev_err_probe() fits the needs, so use it. Signed-off-by: Vasileios Amoiridis <vassilisamir@xxxxxxxxx> --- drivers/iio/chemical/bme680_core.c | 29 +++++++++++------------------ 1 file changed, 11 insertions(+), 18 deletions(-) diff --git a/drivers/iio/chemical/bme680_core.c b/drivers/iio/chemical/bme680_core.c index 0390c298fdd8..b357871ef601 100644 --- a/drivers/iio/chemical/bme680_core.c +++ b/drivers/iio/chemical/bme680_core.c @@ -866,18 +866,14 @@ int bme680_core_probe(struct device *dev, struct regmap *regmap, ret = regmap_write(regmap, BME680_REG_SOFT_RESET, BME680_CMD_SOFTRESET); - if (ret < 0) { - dev_err(dev, "Failed to reset chip\n"); - return ret; - } + if (ret < 0) + return dev_err_probe(dev, ret, "Failed to reset chip\n"); usleep_range(BME680_STARTUP_TIME_US, BME680_STARTUP_TIME_US + 1000); ret = regmap_read(regmap, BME680_REG_CHIP_ID, &data->check); - if (ret < 0) { - dev_err(dev, "Error reading chip ID\n"); - return ret; - } + if (ret < 0) + return dev_err_probe(dev, ret, "Error reading chip ID\n"); if (data->check != BME680_CHIP_ID_VAL) { dev_err(dev, "Wrong chip ID, got %x expected %x\n", @@ -887,22 +883,19 @@ int bme680_core_probe(struct device *dev, struct regmap *regmap, ret = bme680_read_calib(data, &data->bme680); if (ret < 0) { - dev_err(dev, + return dev_err_probe(dev, ret, "failed to read calibration coefficients at probe\n"); - return ret; } ret = bme680_chip_config(data); - if (ret < 0) { - dev_err(dev, "failed to set chip_config data\n"); - return ret; - } + if (ret < 0) + return dev_err_probe(dev, ret, + "failed to set chip_config data\n"); ret = bme680_gas_config(data); - if (ret < 0) { - dev_err(dev, "failed to set gas config data\n"); - return ret; - } + if (ret < 0) + return dev_err_probe(dev, ret, + "failed to set gas config data\n"); return devm_iio_device_register(dev, indio_dev); } -- 2.25.1