Replace write() data_format by regmap_update_bits(), because
bus specific pre-configuration may have happened before on
the same register. Changes then need to be masked.
Remove the data_range field from the struct adxl345_data,
because it is not used anymore.
Signed-off-by: Lothar Rubusch <l.rubusch@xxxxxxxxx>
---
drivers/iio/accel/adxl345_core.c | 9 ++++-----
1 file changed, 4 insertions(+), 5 deletions(-)
diff --git a/drivers/iio/accel/adxl345_core.c b/drivers/iio/accel/adxl345_core.c
index ae12836b5..33424edca 100644
--- a/drivers/iio/accel/adxl345_core.c
+++ b/drivers/iio/accel/adxl345_core.c
@@ -42,13 +42,13 @@
#define ADXL345_DATA_FORMAT_4G 1
#define ADXL345_DATA_FORMAT_8G 2
#define ADXL345_DATA_FORMAT_16G 3
+#define ADXL345_DATA_FORMAT_MSK ~((u8) BIT(6)) /* ignore spi-3wire */
#define ADXL345_DEVID 0xE5
struct adxl345_data {
const struct adxl345_chip_info *info;
struct regmap *regmap;
- u8 data_range;
};
#define ADXL345_CHANNEL(index, axis) { \
@@ -227,14 +227,13 @@ int adxl345_core_probe(struct device *dev, struct regmap *regmap,
data = iio_priv(indio_dev);
data->regmap = regmap;
/* Enable full-resolution mode */
- data->data_range = ADXL345_DATA_FORMAT_FULL_RES;
data->info = device_get_match_data(dev);
if (!data->info)
return -ENODEV;
- ret = regmap_write(data->regmap, ADXL345_REG_DATA_FORMAT,
- data->data_range);
- if (ret < 0)
+ ret = regmap_update_bits(regmap, ADXL345_REG_DATA_FORMAT,
+ ADXL345_DATA_FORMAT_MSK, ADXL345_DATA_FORMAT_FULL_RES);
+ if (ret)
return dev_err_probe(dev, ret, "Failed to set data range\n");
indio_dev->name = data->info->name;
--
2.25.1
