On Tue, 19 Dec 2023 14:32:51 +0530 Anshul Dalal <anshulusr@xxxxxxxxx> wrote: > Adds driver for the MCP48xx series of DACs. > > Device uses a simplex SPI channel. To set the value of an output channel, > a 16-bit data of following format must be written: > > Bit field | Description > 15 [MSB] | Channel selection bit > 0 -> Channel A > 1 -> Channel B > 13 | Output Gain Selection bit > 0 -> 2x Gain (Vref = 4.096V) > 1 -> 1x Gain (Vref = 2.048V) > 12 | Output Shutdown Control bit > 0 -> Shutdown the selected channel > 1 -> Active mode operation > 11-0 [LSB]| DAC Input Data bits > Value's big endian representation is taken as input for the > selected DAC channel. For devices with a resolution of less > than 12-bits, only the x most significant bits are considered > where x is the resolution of the device. > Reference: Page#22 [MCP48x2 Datasheet] > > Supported devices: > +---------+--------------+-------------+ > | Device | Resolution | Channels | > |---------|--------------|-------------| > | MCP4801 | 8-bit | 1 | > | MCP4802 | 8-bit | 2 | > | MCP4811 | 10-bit | 1 | > | MCP4812 | 10-bit | 2 | > | MCP4821 | 12-bit | 1 | > | MCP4822 | 12-bit | 2 | > +---------+--------------+-------------+ > > Devices tested: > MCP4821 [12-bit single channel] > MCP4802 [8-bit dual channel] > > Tested on Raspberry Pi Zero 2W > > Datasheet: https://ww1.microchip.com/downloads/en/DeviceDoc/22244B.pdf #MCP48x1 > Datasheet: https://ww1.microchip.com/downloads/en/DeviceDoc/20002249B.pdf #MCP48x2 > Signed-off-by: Anshul Dalal <anshulusr@xxxxxxxxx> > > --- > > Changes for v3,4: > - no updates Comments were on v2 from me.
