On Thu, 7 Dec 2023 15:38:53 -0300
Marcelo Schmitt <marcelo.schmitt@xxxxxxxxxx> wrote:
> The ad7091r-base driver sets up an interrupt handler for firing events
> when inputs are either above or below a certain threshold.
> However, for the interrupt signal to come from the device it must be
> configured to enable the ALERT/BUSY/GPO pin to be used as ALERT, which
> was not being done until now.
> Enable interrupt signals on the ALERT/BUSY/GPO pin by setting the proper
> bit in the configuration register.
>
> Signed-off-by: Marcelo Schmitt <marcelo.schmitt@xxxxxxxxxx>
Also a fix? Feels like people expect this to work but I guess we could
in theory call it a 'feature' given it never did :)
Jonathan
> ---
> drivers/iio/adc/ad7091r-base.c | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/drivers/iio/adc/ad7091r-base.c b/drivers/iio/adc/ad7091r-base.c
> index 0f192fbecbd4..6056a66d756c 100644
> --- a/drivers/iio/adc/ad7091r-base.c
> +++ b/drivers/iio/adc/ad7091r-base.c
> @@ -28,6 +28,7 @@
> #define AD7091R_REG_RESULT_CONV_RESULT(x) ((x) & 0xfff)
>
> /* AD7091R_REG_CONF */
> +#define AD7091R_REG_CONF_ALERT_EN BIT(4)
> #define AD7091R_REG_CONF_AUTO BIT(8)
> #define AD7091R_REG_CONF_CMD BIT(10)
>
> @@ -232,6 +233,11 @@ int ad7091r_probe(struct device *dev, const char *name,
> iio_dev->channels = chip_info->channels;
>
> if (irq) {
> + ret = regmap_update_bits(st->map, AD7091R_REG_CONF,
> + AD7091R_REG_CONF_ALERT_EN, BIT(4));
> + if (ret)
> + return ret;
> +
> dev_set_drvdata(st->dev, iio_dev);
> ret = devm_request_threaded_irq(dev, irq, NULL,
> ad7091r_event_handler,
