The driver supports continuous reads of temperature and CO2 concentration
through two dedicated IIO channels. It also supports calibration and error
inspection through the concentration channel ext_info.
A few substantial changes in v4, mostly in the calibration attributes
definition but also in the driver code
v3->v4
- Rebased on v5.14
- Remove unneeded Kconfig symbol dependencies
- Remove unused header inclusion
- Lock access to calibration and error status
- Fix temperature scale
- Fix for_each_set_bit()
- Drop a few fields from driver's main structure
- Lock the 'wakeup' session with an additional mutex
- Disable regmap locking as the access to the i2c bus is now externally locked
- Rework the calibration attributes defintion: one attribute per calibration
mode
- Make 'error_status' attributes SHARED_BY_ALL
- Replace regmap_read_poll_timeout() with read_poll_timeout() to use
the driver's byte read function that performs the proper chip 'wakeup'.
It used to work with the previous version too, a few spurious NAK apart but
this seems cleaner and allows to relax the sleep time
- Update ABI documentation according to the new attributes layout
- Remove label from bindings doc
v2->v3:
- [1/3]
- Fix syntax error reported by dt_binding_check
The device node label in the example cannot contain '-'
- Add 'Typically' to the gpios polarities description
- [2/3]
- As suggested by Andy:
- depends on OF, SYSFS; select REGMAP_I2C
- Fix style issues:
- span over 80 cols where appropriate
- remove , in last entries of all arrays
- use for_each_set_bit in sunrise_error_status_read()
- minor style issues (brakets, empty lines, wording)
v1->v2:
- Add ABI documentation in [3/3]
- [1/3]
- Address Rob's comments on missing maxItem and add device node label
- Do not change the pin's polarity description as suggested by Andy due to
conflicting suggestions
- [2/3]
- Expand Kconfig symbol name and change driver's name as suggested by Andy
- Use regmap instead of raw smbus calls as suggested by Andy
- Take into account minor style comments from Andy
- Install channel's ext_info to support calibration triggering and enumerate
calibration modes and error status
- Matt suggested to use sysfs attributes, but I found the per-channel
attributes more appropriate. Hope this is good as well.
Jacopo Mondi (3):
dt-bindings: iio: chemical: Document senseair,sunrise CO2 sensor
iio: chemical: Add Senseair Sunrise 006-0-007 driver
iio: ABI: docs: Document Senseair Sunrise ABI
.../sysfs-bus-iio-chemical-sunrise-co2 | 38 ++
.../iio/chemical/senseair,sunrise.yaml | 55 +++
.../devicetree/bindings/vendor-prefixes.yaml | 2 +
MAINTAINERS | 6 +
drivers/iio/chemical/Kconfig | 10 +
drivers/iio/chemical/Makefile | 1 +
drivers/iio/chemical/sunrise_co2.c | 462 ++++++++++++++++++
7 files changed, 574 insertions(+)
create mode 100644 Documentation/ABI/testing/sysfs-bus-iio-chemical-sunrise-co2
create mode 100644 Documentation/devicetree/bindings/iio/chemical/senseair,sunrise.yaml
create mode 100644 drivers/iio/chemical/sunrise_co2.c
--
2.32.0
