This series adds some fixes and improvements for the ADIS library and devices. There are two fixes: 1) On the library 'adis_init()' function, a call to 'adis_enable_irq()' was being done. That does not make sense because '__adis_initial_startup()' will reset the device and put the data ready pin in the default state. For some drivers, these could mean that we were leaving probe in a state different from the desired one. 2) The adis16480 driver was registering a managed reset action to put the device into sleep mode in the unbinding path. Well, not all devices supported by the driver support sleep mode. The rest of the series is a minor improvement about passing the handling of enabling/disabling IRQs (for devices that cannot unmask the data ready pin) inside the library. Nuno Sá (5): iio: adis: do not disabe IRQs in 'adis_init()' iio: adis: handle devices that cannot unmask the drdy pin iio: adis16475: make use of the new unmasked_drdy flag iio: adis16460: make use of the new unmasked_drdy flag iio: adis16480: fix devices that do not support sleep mode drivers/iio/imu/adis.c | 17 ++++++++++++++++- drivers/iio/imu/adis16460.c | 18 +----------------- drivers/iio/imu/adis16475.c | 19 +------------------ drivers/iio/imu/adis16480.c | 14 +++++++++++--- drivers/iio/imu/adis_trigger.c | 4 ++++ include/linux/iio/imu/adis.h | 2 ++ 6 files changed, 35 insertions(+), 39 deletions(-) -- 2.33.0
