This series makes it possible to set up interrupts with the BMC150 driver on boards where only the INT2 pin is connected (and not INT1). This is particularly always the case for BMC156 since for some reason it only has the INT2 pin and not the INT1 pin. These changes were already partially discussed here: https://lore.kernel.org/linux-iio/YMOphuXSoODIVX06@xxxxxxxxxxx/ Changes in v2: - PATCH 1/4: Clarify order of "interrupts" with "interrupt-names" - PATCH 4/4: Wrap a long line, clarify BOSCH_UNKNOWN with a comment v1: https://lore.kernel.org/linux-iio/20210719112156.27087-1-stephan@xxxxxxxxxxx/ Stephan Gerhold (4): dt-bindings: iio: accel: bma255: Add interrupt-names dt-bindings: iio: accel: bma255: Add bosch,bmc156_accel iio: accel: bmc150: Make it possible to configure INT2 instead of INT1 iio: accel: bmc150: Add support for BMC156 .../bindings/iio/accel/bosch,bma255.yaml | 34 +++++++- drivers/iio/accel/Kconfig | 5 +- drivers/iio/accel/bmc150-accel-core.c | 78 +++++++++++++++---- drivers/iio/accel/bmc150-accel-i2c.c | 10 ++- drivers/iio/accel/bmc150-accel-spi.c | 10 ++- drivers/iio/accel/bmc150-accel.h | 20 ++++- 6 files changed, 134 insertions(+), 23 deletions(-) -- 2.32.0
