From: Meng Li <Meng.Li@xxxxxxxxxxxxx>
When read adc conversion value with below command:
cat /sys/.../iio:device0/in_voltage0-voltage1_raw
There is an error reported as below:
ltc2497 0-0014: i2c transfer failed: -EREMOTEIO
This i2c transfer issue is introduced by commit 69548b7c2c4f ("iio:
adc: ltc2497: split protocol independent part in a separate module").
When extract the common code into ltc2497-core.c, it change the
code logic of function ltc2497core_read(). With wrong reading
sequence, the action of enable adc channel is sent to chip again
during adc channel is in conversion status. In this way, there is
no ack from chip, and then cause i2c transfer failed.
In order to keep the code logic is the same with original ideal,
it is need to return direct after reading the adc conversion value.
v2:
According to ltc2497 datasheet, the max value of conversion time is
149.9 ms. So, add 20% to the 150msecs so that there is enough time
for data conversion.
Fixes: 69548b7c2c4f ("iio: adc: ltc2497: split protocol independent part in a separate module ")
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Meng Li <Meng.Li@xxxxxxxxxxxxx>
---
drivers/iio/adc/ltc2497.c | 2 ++
drivers/iio/adc/ltc2497.h | 2 +-
2 files changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/iio/adc/ltc2497.c b/drivers/iio/adc/ltc2497.c
index 1adddf5a88a9..fd5a66860a47 100644
--- a/drivers/iio/adc/ltc2497.c
+++ b/drivers/iio/adc/ltc2497.c
@@ -41,6 +41,8 @@ static int ltc2497_result_and_measure(struct ltc2497core_driverdata *ddata,
}
*val = (be32_to_cpu(st->buf) >> 14) - (1 << 17);
+
+ return ret;
}
ret = i2c_smbus_write_byte(st->client,
diff --git a/drivers/iio/adc/ltc2497.h b/drivers/iio/adc/ltc2497.h
index d0b42dd6b8ad..e451930837d8 100644
--- a/drivers/iio/adc/ltc2497.h
+++ b/drivers/iio/adc/ltc2497.h
@@ -2,7 +2,7 @@
#define LTC2497_ENABLE 0xA0
#define LTC2497_CONFIG_DEFAULT LTC2497_ENABLE
-#define LTC2497_CONVERSION_TIME_MS 150ULL
+#define LTC2497_CONVERSION_TIME_MS 180ULL
struct ltc2497core_driverdata {
struct regulator *ref;
--
2.17.1
