On Mon May 31, 2021 at 12:25 PM EDT, Peter Rosin wrote: > On 2021-05-31 16:51, Liam Beguin wrote: > > On Mon May 31, 2021 at 10:08 AM EDT, Peter Rosin wrote: > >> On 2021-05-31 15:36, Liam Beguin wrote: > >>> Hi Peter, > >>> > >>> On Mon May 31, 2021 at 4:52 AM EDT, Peter Rosin wrote: > >>>> Hi! > >>>> > >>>> Thanks for the patch! > >>>> > >>>> On 2021-05-30 02:59, Liam Beguin wrote: > >>>>> From: Liam Beguin <lvb@xxxxxxxxxx> > >>>>> > >>>>> This is a preparatory change required for the addition of temperature > >>>>> sensing front ends. > >>>> > >>>> I think this is too simplistic. I think that if the upstream iio-dev has > >>>> an offset, it should be dealt with (i.e. be rescaled). The rescale > >>>> driver > >>>> cannot ignore such an upstream offset and then throw in some other > >>>> unrelated offset of its own. That would be thoroughly confusing. > >>> > >>> I'm not sure I fully understand. The upstream offset should be dealt > >>> with when calling iio_read_channel_processed(). That was my main > >>> motivation behind using the IIO core to get a processed value. > >> > >> You can rescale a channel with an offset, but without using processed > >> values. I.e. the upstream channel provides raw values, a scale and an > >> offset. The current rescale code ignores the upstream offset. I did not > >> need that when I created the driver, and at a glace it felt "difficult". > >> So I punted. > > > > I understand what you meant now. > > > > At first, I tried to apply the upstream offset from inside the rescaler. > > As you said it felt difficult and it felt like this must've been > > implemented somewhere else before. > > > > After looking around, I noticed that the code to do that was already > > part of inkern.c and exposed through iio_read_channel_processed(). > > If the upstream channel doesn't provide a processed value, the upstream > > offset and scale are automatically applied. > > > > So with the changes in [3/9] the rescaler's raw value becomes the > > upstream channel's processed value. > > > > This seems like an easier and probably cleaner way of adding offset > > support in the rescaler. > > > > Does that make sense? > > Yes, it does. Doing generic calculations like this efficiently with > integer math without losing precision is ... difficult. You're right, I realized it's more complicated that it seems working on this. > > I think that perhaps IF the upstream channel has an offset, the > rescaler could revert to always use the upstream processed channel in > preference of the raw channel. That would fix the missing support for > upstream offset and still not penalize the sweet case of no upstream > offset. Because the processed channel costs processing for each and > every sample and I think it should be avoided as much as possible. > > Does that make sense? Totally, I see what you're saying and will give it a try. I still believe it would make sense to get the upstream scaling factor the same way, to avoid duplicating that code. Also it might be confusing to have the raw value be the upstream raw value in some cases and the upstream processed value in others. > > Or are a bunch of drivers adding an explicit zero offset "just because"? > That would be a nuisance. A quick search seems to indicate that this isn't the case. Thanks for your time, Liam > > Cheers, > Peter
