All volt-temp tables here are sorted in descending order. There is no need to accout for (unused) ascending table sorting case, so simplify the conversion function. Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx> --- drivers/iio/adc/qcom-vadc-common.c | 21 +-------------------- 1 file changed, 1 insertion(+), 20 deletions(-) diff --git a/drivers/iio/adc/qcom-vadc-common.c b/drivers/iio/adc/qcom-vadc-common.c index 0c705bb473fe..441843827f05 100644 --- a/drivers/iio/adc/qcom-vadc-common.c +++ b/drivers/iio/adc/qcom-vadc-common.c @@ -346,38 +346,19 @@ static struct qcom_adc5_scale_type scale_adc5_fn[] = { static int qcom_vadc_map_voltage_temp(const struct vadc_map_pt *pts, u32 tablesize, s32 input, int *output) { - bool descending = 1; u32 i = 0; if (!pts) return -EINVAL; - /* Check if table is descending or ascending */ - if (tablesize > 1) { - if (pts[0].x < pts[1].x) - descending = 0; - } - - while (i < tablesize) { - if ((descending) && (pts[i].x < input)) { - /* table entry is less than measured*/ - /* value and table is descending, stop */ - break; - } else if ((!descending) && - (pts[i].x > input)) { - /* table entry is greater than measured*/ - /*value and table is ascending, stop */ - break; - } + while (i < tablesize && pts[i].x > input) i++; - } if (i == 0) { *output = pts[0].y; } else if (i == tablesize) { *output = pts[tablesize - 1].y; } else { - /* result is between search_index and search_index-1 */ /* interpolate linearly */ *output = fixp_linear_interpolate(pts[i - 1].x, pts[i - 1].y, pts[i].x, pts[i].y, -- 2.29.2