Hi, The next 3 patches do the following: - The first patch adds PNI Sensor Corporation to the vendor prefix list. - The second patch adds devicetree binding for RM3100 magnetometer. - The third patch adds the driver for RM3100 magnetometer. -- Song Qiang Changes in v4: - Fix a bug about regmap_range configurations. - Add DRDY trigger support. - Change DRDY interrupt trigger source from RISING to HIGH. - Add a thread function to clear the interrupt. - Change the logic of one-shot read from waiting next continuous ends to writing to POLL register and waiting conversion ends. - Add iio_buffer_setup_ops to enable continuous conversion only when buffer is enabled. - Add active_scan_mask check in continuous conversions. - Remove *wait_measurement() in *trigger_handler(). Changes in v3: - Change PNI to PNI Sensor Corporation in vendor-prefix.txt. - Sort header files in alpabetical order. - Add more specific doc for the mutex. - Fix the bug in the rm3100_set_cycle_count() where we always set the cycle count value to 100 no matter what val is. - Change some multiple else if to switch. - Remove iio_device_release_direct_mode() in the case claim direct mode fails. - Use the same buffer in rm3100_trigger_handler(). - Add space around some operators. - Add manually unwind functions in case devm_add_action() fails. - Move devm_add_action before the devm_iio_device_register(). - Move register defines and rm3100_data struct to *-core.c. - Change some storage variable type of regmap from int to unsigned int. - Change 10e4 to 10^4. - Remove explicit cast of data pointer in rm3100_remove(). - Remve dev in rm3100_data and use regmap_get_device() to obtain device pointer instead. - Change register bits alignment in defines. - Move RM3100_SCAN_BYTES to the top. - Change Channel endieness from LE to BE. - Adjust the place of comment about the 3 second wait time. - Some spell check. Changes in v2: - Add scale channel. - Add EXPORT_SYMBOL_GPL() to export regmap confuguration structures. - Add sampling frequency available attribute. - Clean up headers and License declarations. - Change axis number to 3. - Remove bus specific part in compatible string. - Remove le32_to_cpu(). - Check cycle count registers at *_probe(). - Format comments. - Spell check. - Change prefix from RM_* to RM3100_*. - Check all error return paths. - Add devm_add_action() to avoid race condition when remove. Song Qiang (3): dt-bindings: Add PNI to the vendor prefixes. iio: magnetometer: Add DT support for PNI RM3100 iio: magnetometer: Add driver support for PNI RM3100 .../bindings/iio/magnetometer/pni,rm3100.txt | 20 + .../devicetree/bindings/vendor-prefixes.txt | 1 + MAINTAINERS | 7 + drivers/iio/magnetometer/Kconfig | 29 + drivers/iio/magnetometer/Makefile | 4 + drivers/iio/magnetometer/rm3100-core.c | 627 ++++++++++++++++++ drivers/iio/magnetometer/rm3100-i2c.c | 58 ++ drivers/iio/magnetometer/rm3100-spi.c | 64 ++ drivers/iio/magnetometer/rm3100.h | 17 + 9 files changed, 827 insertions(+) create mode 100644 Documentation/devicetree/bindings/iio/magnetometer/pni,rm3100.txt create mode 100644 drivers/iio/magnetometer/rm3100-core.c create mode 100644 drivers/iio/magnetometer/rm3100-i2c.c create mode 100644 drivers/iio/magnetometer/rm3100-spi.c create mode 100644 drivers/iio/magnetometer/rm3100.h -- 2.17.1
