The current structs are only partially documented via annotations. This
change updates annotations for all structs in the ad7606.h file.
Signed-off-by: Alexandru Ardelean <alexandru.ardelean@xxxxxxxxxx>
---
drivers/staging/iio/adc/ad7606.h | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)
diff --git a/drivers/staging/iio/adc/ad7606.h b/drivers/staging/iio/adc/ad7606.h
index 4983e3aa6b0e..f422296354c9 100644
--- a/drivers/staging/iio/adc/ad7606.h
+++ b/drivers/staging/iio/adc/ad7606.h
@@ -24,7 +24,26 @@ struct ad7606_chip_info {
/**
* struct ad7606_state - driver instance specific data
+ * @dev pointer to kernel device
+ * @chip_info entry in the table of chips that describes this device
+ * @reg regulator info for the the power supply of the device
+ * @poll_work struct info for reading data in buffer mode
+ * @wq_data_avail wait queue struct for buffer mode
+ * @bops bus operations (SPI or parallel)
+ * @range voltage range selection, selects which scale to apply
+ * @oversampling oversampling selection
+ * @done marks whether reading data is done
+ * @base_address address from where to read data in parallel operation
* @lock protect sensor state
+ * @gpio_convst GPIO descriptor for conversion start signal (CONVST)
+ * @gpio_reset GPIO descriptor for device hard-reset
+ * @gpio_range GPIO descriptor for range selection
+ * @gpio_standby GPIO descriptor for stand-by signal (STBY),
+ * controls power-down mode of device
+ * @gpio_frstdata GPIO descriptor for reading from device when data
+ * is being read on the first channel
+ * @gpio_os GPIO descriptors to control oversampling on the device
+ * @data buffer for reading data from the device
*/
struct ad7606_state {
@@ -55,6 +74,10 @@ struct ad7606_state {
unsigned short data[12] ____cacheline_aligned;
};
+/**
+ * struct ad7606_bus_ops - driver bus operations
+ * @read_block function pointer for reading blocks of data
+ */
struct ad7606_bus_ops {
/* more methods added in future? */
int (*read_block)(struct device *dev, int num, void *data);
--
2.17.1
