On Fri, 2016-09-02 at 12:12 -0300, Fabio Estevam wrote:
> On Fri, Sep 2, 2016 at 12:04 PM, Christoph Fritz
> <chf.fritz@xxxxxxxxxxxxxx> wrote:
>
> > Here on my board I'm using the reset pin as an open-drain with external
> > pullup, so GPIO_ACTIVE_HIGH is valid.
> >
> > As this is an example, I don't care if it says _HIGH or _LOW.
>
> Then probably it is better to remove "reset-gpios" from the example.
>
> The driver does not parse this dt property and the reset is being done
> via software command as far as I can see.
What do you mean by "software command", to send a reset command by i2c?
The reset GPIO is fetched in sx9500 here:
See sx9500_gpio_probe():
...
data->gpiod_rst = devm_gpiod_get_index(dev, SX9500_GPIO_RESET,
0, GPIOD_OUT_HIGH);
...
--
To unsubscribe from this list: send the line "unsubscribe linux-iio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
