On Mon, Jul 16, 2018 at 09:54:16AM -0600, Rob Herring wrote:
> On Fri, Jul 13, 2018 at 11:03:01AM +0000, Corentin Labbe wrote:
> > This patch document the new optional resets for ahci node.
> >
> > Signed-off-by: Corentin Labbe <clabbe@xxxxxxxxxxxx>
> > ---
> > Documentation/devicetree/bindings/ata/ahci-platform.txt | 2 ++
> > 1 file changed, 2 insertions(+)
> >
> > diff --git a/Documentation/devicetree/bindings/ata/ahci-platform.txt b/Documentation/devicetree/bindings/ata/ahci-platform.txt
> > index 5f362af2724c..a5281d7557e3 100644
> > --- a/Documentation/devicetree/bindings/ata/ahci-platform.txt
> > +++ b/Documentation/devicetree/bindings/ata/ahci-platform.txt
> > @@ -34,6 +34,8 @@ Optional properties:
> > - phys : reference to the SATA PHY node
> > - phy-names : must be "sata-phy"
> > - ahci-supply : regulator for AHCI controller
> > +- resets : phandle to the reset line of AHCI controller
> > + If set, must have a reset-names set as "ahci"
>
> A name is pointless if there is only one. Also, the name should be what
> the signal in the block is called which I doubt would be called "ahci".
> A likely name is some form of reset, resetn, etc. which again is
> pointless to name if there is only 1.
>
> If you do have 'reset-names' then that needs to be listed too like
> phy-names.
>
Since the ahci-platform code is common to lots of different drivers, I must have a name otherwise I could grab a reset which wasnt for me.
See the revert of f0f56716fc3e ("ata: ahci-platform: add reset control support") for example.
So the code need to grab a name, and since this name could be used by other people I took the generic "ahci".
In my case (R40), the reset is called sata, so I will change reset-names to "sata" in my next serie.
Regards
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
