Re: No I/O errors reported after SATA link hard reset

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hello,

On Thu, Aug 17, 2017 at 03:18:06PM +0200, Bernd Schubert wrote:
> So for Gionatan the root cause was an instable power supply, but in my
> case there wasn't any power loss, there were just failed sata commands.
> I'm not sure if this was a port or cable issue - once I changed port and
> sata cable the errors disappeared. I didn't change the power supply or
> power cable. I'm now basically fighting with the data corruption that
> caused - for btrfs it at least has a checksum, but I didn't have ext4
> checksum enabled, so it is hard to figure out which files are corrupts -
> silent data corruption is not well handled by backups either.

No idea there.  Retried and recovered errors shouldn't cause data
corruptions.  Flaky power can behave in unexpected ways tho.  What
happens if you hook up the drive on a different power supply but
revert to the port / cable which showed the problem?  What does your
SMART counters say across those failures?

> Is it possible that sata eh recovery sends resets to the device, which
> makes it evict its cache?

That'd be a very broken device.  It sure is theoretically possible but
I haven't seen any reports on such behaviors yet.

Thanks.

-- 
tejun
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux