Andy Shevchenko <andy.shevchenko@xxxxxxxxx> writes: > On Sun, Dec 20, 2015 at 8:49 PM, Måns Rullgård <mans@xxxxxxxxx> wrote: >> Julian Margetson <runaway@xxxxxxxx> writes: >>> On 12/20/2015 1:11 PM, Måns Rullgård wrote: >>>> Julian Margetson <runaway@xxxxxxxx> writes: > >>> [ 48.769671] ata3.00: failed command: READ FPDMA QUEUED >> >> Well, that didn't help. I still think it's part of the problem, but >> something else must be wrong as well. The various Master Select fields >> look like a good place to start. > > Master number (which is here would be either 1 or 0) should not affect > as long as they are connected to the same AHB bus (I would be > surprised if they are not). I think they are not. The relevant part of the block diagram for the 460EX looks something like this: +-----+ +-----+ +-----+ +------+ | CPU |<==>| BUS |<==>| DMA |<==>| SATA | +-----+ +-----+ +-----+ +------+ >> Also, the manual says the LLP_SRC_EN >> and LLP_DST_EN flags should be cleared on the last in a chain of blocks. >> The old sata_dwc driver does this whereas dw_dma does not. > > Easy to fix, however I can't get how it might affect. > >> It might be worthwhile to try reverting drivers/ata/sata_dwc_460ex.c to >> v4.0 (leaving the rest at 4.4-rc5) just to make sure that's a good >> reference. I've verified that this builds. > > It would be nice. > > I noticed thanks to DWC_PARAMS that burst size is hardcoded to 32 > items on this board, however registers for SATA program it to 64. I > remember that I got no interrupt when I programmed transfer width > wrongly (64 bits against 32 bits) when I ported dw_dmac to be used on > Intel SoCs. > > -- > With Best Regards, > Andy Shevchenko -- Måns Rullgård -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
