Hello, Jian. On 12/08/2010 09:09 PM, Jian Peng wrote: > The controller may take much longer time to recover in this case, > and leads to wrong HW state after stop_engine() inside > ahci_hardreset() and cause device type checking failure due to > unfinished HW state change and missing D2H FIS after start_engine() > again inside ahci_hardreset(). I guess this is the reason why AHCI > spec try to emphasize. I don't necessarily agree there. The requirement is impossible to reliably satisfy to begin with (it's inherently racy) and most specs are filled with "the outcome is undefined" when they don't _need_ to be well defined. The hardware can do "eh.. well, whatever, I don't know" but shouldn't get lost and fail to react to further state-resetting actions. > Yes, without this change, Broadcom controller will fail due to above > reason. Okay, so, the controller goes bonkers if ST is set when prerequisites are not met. You know that the problem can still happen with the proposed change, right? It's much less likely but definitely can and actually is likely to happen once in a blue moon. It isn't too uncommon for link to take some time to stabilize after a PHY event (including hardreset) and some devices will end up sending multiple D2H Reg FISes in the process with conflicting status. Also, note that the delay between the check and ST setting could be substantial especially with parallel probing / booting. I'm not objecting to the change but you guys probably want to fix the controller in following revisions. If we're gonna make the change, I'd like to go with the previous version without the vendor check. What is the timeframe for the controller release? Would it be enough to merge the change during 2.6.38-rc1? After baking it for some time in 2.6.38, we can propagate the change back through -stable. Thanks. -- tejun -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html