Re: [RFC][PATCH] sata_mv: harddisk activity led no longer responsive on QNAP TS-109

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



* saeed bishara <saeed.bishara@xxxxxxxxx> [2009-02-24 11:33]:
> What I think is that this issue is seen with the specific disk that
> you have, the chip blinks the LED depending on the BUSY bit status,
> and I suspect that with the disk you have does clear that bit
> immediately after receiving the command FIS, so the LED will be off,
> though the command is not completed yet, and this makes the led
> responsiveness differ that in NCQ-disabled mode.

The LED issue was reported by two people on the QNAP forum the other
day.  I asked what disks they had and one has a WDC WD7500AACS-00D6B0
whereas the other one has a WDC WD10EADS-00L5B1.  Do you also use a
WDC disk, Frans?

References:
http://forum.qnap.com/viewtopic.php?f=147&t=1344&start=220#p55925
http://forum.qnap.com/viewtopic.php?f=147&t=1344&start=220#p56027
http://forum.qnap.com/viewtopic.php?f=147&t=1344&start=230#p56351
-- 
Martin Michlmayr
http://www.cyrius.com/
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux