Notable notes: Alan's two fixes haven't seen much testing, but they
really need to go in to work correctly with the 32bit PIO support
introduced in this release.
Please pull from 'upstream-linus' branch of
master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/libata-dev.git upstream-linus
to receive the following updates:
drivers/ata/pata_amd.c | 76 +++++++++++++++++++++++++++++++++++----------
drivers/ata/pata_it821x.c | 3 ++
drivers/ata/pata_legacy.c | 7 ++--
drivers/ata/sata_mv.c | 20 +++++------
4 files changed, 75 insertions(+), 31 deletions(-)
Alan Cox (2):
[libata] pata_amd: program FIFO
[libata] pata_legacy: for VLB 32bit PIO don't try tricks with slop
Mark Lord (1):
sata_mv: fix SoC interrupt breakage
Ondrej Zary (1):
pata_it821x: resume from hibernation fails with RAID volume
diff --git a/drivers/ata/pata_amd.c b/drivers/ata/pata_amd.c
index 63719ab..115b1cd 100644
--- a/drivers/ata/pata_amd.c
+++ b/drivers/ata/pata_amd.c
@@ -24,7 +24,7 @@
#include <linux/libata.h>
#define DRV_NAME "pata_amd"
-#define DRV_VERSION "0.3.11"
+#define DRV_VERSION "0.4.1"
/**
* timing_setup - shared timing computation and load
@@ -145,6 +145,13 @@ static int amd_pre_reset(struct ata_link *link, unsigned long deadline)
return ata_sff_prereset(link, deadline);
}
+/**
+ * amd_cable_detect - report cable type
+ * @ap: port
+ *
+ * AMD controller/BIOS setups record the cable type in word 0x42
+ */
+
static int amd_cable_detect(struct ata_port *ap)
{
static const u32 bitmask[2] = {0x03, 0x0C};
@@ -158,6 +165,40 @@ static int amd_cable_detect(struct ata_port *ap)
}
/**
+ * amd_fifo_setup - set the PIO FIFO for ATA/ATAPI
+ * @ap: ATA interface
+ * @adev: ATA device
+ *
+ * Set the PCI fifo for this device according to the devices present
+ * on the bus at this point in time. We need to turn the post write buffer
+ * off for ATAPI devices as we may need to issue a word sized write to the
+ * device as the final I/O
+ */
+
+static void amd_fifo_setup(struct ata_port *ap)
+{
+ struct ata_device *adev;
+ struct pci_dev *pdev = to_pci_dev(ap->host->dev);
+ static const u8 fifobit[2] = { 0xC0, 0x30};
+ u8 fifo = fifobit[ap->port_no];
+ u8 r;
+
+
+ ata_for_each_dev(adev, &ap->link, ENABLED) {
+ if (adev->class == ATA_DEV_ATAPI)
+ fifo = 0;
+ }
+ if (pdev->device == PCI_DEVICE_ID_AMD_VIPER_7411) /* FIFO is broken */
+ fifo = 0;
+
+ /* On the later chips the read prefetch bits become no-op bits */
+ pci_read_config_byte(pdev, 0x41, &r);
+ r &= ~fifobit[ap->port_no];
+ r |= fifo;
+ pci_write_config_byte(pdev, 0x41, r);
+}
+
+/**
* amd33_set_piomode - set initial PIO mode data
* @ap: ATA interface
* @adev: ATA device
@@ -167,21 +208,25 @@ static int amd_cable_detect(struct ata_port *ap)
static void amd33_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
+ amd_fifo_setup(ap);
timing_setup(ap, adev, 0x40, adev->pio_mode, 1);
}
static void amd66_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
+ amd_fifo_setup(ap);
timing_setup(ap, adev, 0x40, adev->pio_mode, 2);
}
static void amd100_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
+ amd_fifo_setup(ap);
timing_setup(ap, adev, 0x40, adev->pio_mode, 3);
}
static void amd133_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
+ amd_fifo_setup(ap);
timing_setup(ap, adev, 0x40, adev->pio_mode, 4);
}
@@ -397,6 +442,16 @@ static struct ata_port_operations nv133_port_ops = {
.set_dmamode = nv133_set_dmamode,
};
+static void amd_clear_fifo(struct pci_dev *pdev)
+{
+ u8 fifo;
+ /* Disable the FIFO, the FIFO logic will re-enable it as
+ appropriate */
+ pci_read_config_byte(pdev, 0x41, &fifo);
+ fifo &= 0x0F;
+ pci_write_config_byte(pdev, 0x41, fifo);
+}
+
static int amd_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
{
static const struct ata_port_info info[10] = {
@@ -503,14 +558,8 @@ static int amd_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
if (type < 3)
ata_pci_bmdma_clear_simplex(pdev);
-
- /* Check for AMD7411 */
- if (type == 3)
- /* FIFO is broken */
- pci_write_config_byte(pdev, 0x41, fifo & 0x0F);
- else
- pci_write_config_byte(pdev, 0x41, fifo | 0xF0);
-
+ if (pdev->vendor == PCI_VENDOR_ID_AMD)
+ amd_clear_fifo(pdev);
/* Cable detection on Nvidia chips doesn't work too well,
* cache BIOS programmed UDMA mode.
*/
@@ -536,18 +585,11 @@ static int amd_reinit_one(struct pci_dev *pdev)
return rc;
if (pdev->vendor == PCI_VENDOR_ID_AMD) {
- u8 fifo;
- pci_read_config_byte(pdev, 0x41, &fifo);
- if (pdev->device == PCI_DEVICE_ID_AMD_VIPER_7411)
- /* FIFO is broken */
- pci_write_config_byte(pdev, 0x41, fifo & 0x0F);
- else
- pci_write_config_byte(pdev, 0x41, fifo | 0xF0);
+ amd_clear_fifo(pdev);
if (pdev->device == PCI_DEVICE_ID_AMD_VIPER_7409 ||
pdev->device == PCI_DEVICE_ID_AMD_COBRA_7401)
ata_pci_bmdma_clear_simplex(pdev);
}
-
ata_host_resume(host);
return 0;
}
diff --git a/drivers/ata/pata_it821x.c b/drivers/ata/pata_it821x.c
index f1bb2f9..b05b86a 100644
--- a/drivers/ata/pata_it821x.c
+++ b/drivers/ata/pata_it821x.c
@@ -557,6 +557,9 @@ static unsigned int it821x_read_id(struct ata_device *adev,
id[83] |= 0x4400; /* Word 83 is valid and LBA48 */
id[86] |= 0x0400; /* LBA48 on */
id[ATA_ID_MAJOR_VER] |= 0x1F;
+ /* Clear the serial number because it's different each boot
+ which breaks validation on resume */
+ memset(&id[ATA_ID_SERNO], 0x20, ATA_ID_SERNO_LEN);
}
return err_mask;
}
diff --git a/drivers/ata/pata_legacy.c b/drivers/ata/pata_legacy.c
index 6c1d778..e3bc1b4 100644
--- a/drivers/ata/pata_legacy.c
+++ b/drivers/ata/pata_legacy.c
@@ -283,9 +283,10 @@ static void pdc20230_set_piomode(struct ata_port *ap, struct ata_device *adev)
static unsigned int pdc_data_xfer_vlb(struct ata_device *dev,
unsigned char *buf, unsigned int buflen, int rw)
{
- if (ata_id_has_dword_io(dev->id)) {
+ int slop = buflen & 3;
+ /* 32bit I/O capable *and* we need to write a whole number of dwords */
+ if (ata_id_has_dword_io(dev->id) && (slop == 0 || slop == 3)) {
struct ata_port *ap = dev->link->ap;
- int slop = buflen & 3;
unsigned long flags;
local_irq_save(flags);
@@ -735,7 +736,7 @@ static unsigned int vlb32_data_xfer(struct ata_device *adev, unsigned char *buf,
struct ata_port *ap = adev->link->ap;
int slop = buflen & 3;
- if (ata_id_has_dword_io(adev->id)) {
+ if (ata_id_has_dword_io(adev->id) && (slop == 0 || slop == 3)) {
if (rw == WRITE)
iowrite32_rep(ap->ioaddr.data_addr, buf, buflen >> 2);
else
diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c
index 4ae1a41..7007edd 100644
--- a/drivers/ata/sata_mv.c
+++ b/drivers/ata/sata_mv.c
@@ -3114,19 +3114,17 @@ static int mv_init_host(struct ata_host *host, unsigned int board_idx)
writelfl(0, hc_mmio + HC_IRQ_CAUSE_OFS);
}
- if (!IS_SOC(hpriv)) {
- /* Clear any currently outstanding host interrupt conditions */
- writelfl(0, mmio + hpriv->irq_cause_ofs);
+ /* Clear any currently outstanding host interrupt conditions */
+ writelfl(0, mmio + hpriv->irq_cause_ofs);
- /* and unmask interrupt generation for host regs */
- writelfl(hpriv->unmask_all_irqs, mmio + hpriv->irq_mask_ofs);
+ /* and unmask interrupt generation for host regs */
+ writelfl(hpriv->unmask_all_irqs, mmio + hpriv->irq_mask_ofs);
- /*
- * enable only global host interrupts for now.
- * The per-port interrupts get done later as ports are set up.
- */
- mv_set_main_irq_mask(host, 0, PCI_ERR);
- }
+ /*
+ * enable only global host interrupts for now.
+ * The per-port interrupts get done later as ports are set up.
+ */
+ mv_set_main_irq_mask(host, 0, PCI_ERR);
done:
return rc;
}
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
