Mark Lord wrote:
Robert Hancock wrote:
Luben Tuikov wrote:
--- On Mon, 1/28/08, Robert Hancock <hancockr@xxxxxxx> wrote:
The trick is that if an ATAPI device is connected, we (as
far as I'm aware) can't use ADMA mode, so we have to switch that
port into legacy mode.
Can you double check this with the HW architect of the
HW DMA engine of the ASIC?
Will do so. However, previous statements from NVIDIA fairly clearly
indicate that this is the case.
This means it's only capable of 32-bit DMA.
However the other port on the controller may be connected to a hard
drive and therefore still capable of 64-bit DMA.
If this is indeed the case as you've presented it here,
it sounds like a HW shortcoming. I cannot see how the device
type (or protocol) dictate how the DMA engine operates.
They live in two different domains.
Well, there is an indirect link. The ADMA interface (which supports
64-bit DMA) cannot be used to issue ATAPI commands, so if an ATAPI
device is connected we have to go to legacy mode, which supports only
32-bit DMA.
I'm not sure why ADMA mode doesn't support ATAPI. The only reason I
can think of is that there's issues since ATAPI commands can
potentially be of unpredictable transfer size. The "real" ADMA spec
that the NVIDIA implementation is loosely based on does have some
special "ignore excess" controls that don't seem to be in the NVIDIA
version (or at least not to the knowledge I have on this hardware).
..
The original Pacific Digital ADMA cores *do* support most ATAPI commands
in ADMA mode, including READ_CD, READ_10, etc.. With the caveat that if
DSC completion state is required, the driver has to drop out of ADMA
and poll for it after the ADMA command completes.
Commands which were not ADMA compatible (eg. MODE_SENSE,
TEST_UNIT_READY, ..)
were simply handled with PIO (in the driver) rather than any form of DMA,
which is okay because those commands are relatively infrequent.
Note that Pacific Digital "officially" said "no ATAPI" for the ADMA design,
but I implemented it regardless (for Linux) and it worked rather well.
We could burn DVDs and back-up to tape simultaneously, with the burner
and the tape unit sharing a single IDE cable/channel.
I'm told that the ADMA hardware does have some support for issuing ATAPI
commands, however according to Allen Martin of NVIDIA, "The ATAPI
support in the ADMA hardware had some serious problem that forced us to
turn it off in the Windows driver." So it looks like ATAPI in ADMA mode
is likely a non-starter.
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
