Discussed for 2.6.21, but pushed back because the current SATA code
had enough fun stuff to debug already. Thus, just queued the following
for 2.6.22 in libata-dev.git#upstream.
The nasty ____request_resource hack is finally gone.
In practical terms, this usually means that some combined mode users
will have their SATA devices driven by the old-IDE driver rather than
libata (because old-IDE is often non-modular, and thus probes first).
But really, these same users will IMO cheer the removal of the
performance-killing split-driver configuration, so its a net win.
And the code is smaller and more clean, with one less special case
hack.
libata/IDE: remove combined mode quirk
Both old-IDE and libata should be able handle all controllers and
devices found using normal resource reservation methods.
This eliminates the awful, low-performing split-driver configuration
where old-IDE drove the PATA portion of a PCI device, in PIO-only mode,
and libata drove the SATA portion of the /same/ PCI device, in DMA mode.
Typically vendors would ship SATA hard drive / PATA optical
configuration, which would lend itself to slow (PIO-only) CD-ROM
performance.
For Intel users running in combined mode, it is now wholly dependent on
your driver choice (potentially link order, if you compile both drivers
in) whether old-IDE or libata will drive your hardware.
In either case, you will get full performance from both SATA and PATA
ports now, without having to pass a kernel command line parameter.
Signed-off-by: Jeff Garzik <jeff@xxxxxxxxxx>
arch/i386/defconfig | 1
arch/parisc/configs/c3000_defconfig | 1
arch/x86_64/defconfig | 1
drivers/ata/Kconfig | 5 -
drivers/ata/libata-sff.c | 36 +----------
drivers/pci/quirks.c | 113 ------------------------------------
include/linux/ioport.h | 1
kernel/resource.c | 21 ------
8 files changed, 6 insertions(+), 173 deletions(-)
diff --git a/arch/i386/defconfig b/arch/i386/defconfig
index 5ae1e0b..0b92a95 100644
--- a/arch/i386/defconfig
+++ b/arch/i386/defconfig
@@ -678,7 +678,6 @@ CONFIG_SATA_SIL=y
CONFIG_SATA_VIA=y
# CONFIG_SATA_VITESSE is not set
# CONFIG_SATA_INIC162X is not set
-CONFIG_SATA_INTEL_COMBINED=y
# CONFIG_PATA_ALI is not set
# CONFIG_PATA_AMD is not set
# CONFIG_PATA_ARTOP is not set
diff --git a/arch/parisc/configs/c3000_defconfig b/arch/parisc/configs/c3000_defconfig
index 782906b..eb2f9a3 100644
--- a/arch/parisc/configs/c3000_defconfig
+++ b/arch/parisc/configs/c3000_defconfig
@@ -435,7 +435,6 @@ CONFIG_SCSI_SATA_SIL=m
# CONFIG_SCSI_SATA_ULI is not set
CONFIG_SCSI_SATA_VIA=m
# CONFIG_SCSI_SATA_VITESSE is not set
-CONFIG_SCSI_SATA_INTEL_COMBINED=y
# CONFIG_SCSI_DMX3191D is not set
# CONFIG_SCSI_FUTURE_DOMAIN is not set
# CONFIG_SCSI_IPS is not set
diff --git a/arch/x86_64/defconfig b/arch/x86_64/defconfig
index 293a4a4..6fe4635 100644
--- a/arch/x86_64/defconfig
+++ b/arch/x86_64/defconfig
@@ -622,7 +622,6 @@ CONFIG_SATA_SIL=y
CONFIG_SATA_VIA=y
# CONFIG_SATA_VITESSE is not set
# CONFIG_SATA_INIC162X is not set
-CONFIG_SATA_INTEL_COMBINED=y
# CONFIG_PATA_ALI is not set
# CONFIG_PATA_AMD is not set
# CONFIG_PATA_ARTOP is not set
diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig
index 131a9f7..54ee50b 100644
--- a/drivers/ata/Kconfig
+++ b/drivers/ata/Kconfig
@@ -156,11 +156,6 @@ config SATA_INIC162X
help
This option enables support for Initio 162x Serial ATA.
-config SATA_INTEL_COMBINED
- bool
- depends on IDE=y && !BLK_DEV_IDE_SATA && (SATA_AHCI || ATA_PIIX)
- default y
-
config SATA_ACPI
bool
depends on ACPI && PCI
diff --git a/drivers/ata/libata-sff.c b/drivers/ata/libata-sff.c
index 066689c..0a19466 100644
--- a/drivers/ata/libata-sff.c
+++ b/drivers/ata/libata-sff.c
@@ -779,40 +779,16 @@ int ata_pci_init_one (struct pci_dev *pdev, struct ata_port_info **port_info,
/* Deal with combined mode hack. This side of the logic all
goes away once the combined mode hack is killed in 2.6.21 */
if (!devm_request_region(dev, ATA_PRIMARY_CMD, 8, "libata")) {
- struct resource *conflict, res;
- res.start = ATA_PRIMARY_CMD;
- res.end = ATA_PRIMARY_CMD + 8 - 1;
- conflict = ____request_resource(&ioport_resource, &res);
- while (conflict->child)
- conflict = ____request_resource(conflict, &res);
- if (!strcmp(conflict->name, "libata"))
- legacy_mode |= ATA_PORT_PRIMARY;
- else {
- pcim_pin_device(pdev);
- printk(KERN_WARNING "ata: 0x%0X IDE port busy\n" \
- "ata: conflict with %s\n",
- ATA_PRIMARY_CMD,
- conflict->name);
- }
+ pcim_pin_device(pdev);
+ printk(KERN_WARNING "ata: 0x%0X IDE port busy\n",
+ ATA_PRIMARY_CMD);
} else
legacy_mode |= ATA_PORT_PRIMARY;
if (!devm_request_region(dev, ATA_SECONDARY_CMD, 8, "libata")) {
- struct resource *conflict, res;
- res.start = ATA_SECONDARY_CMD;
- res.end = ATA_SECONDARY_CMD + 8 - 1;
- conflict = ____request_resource(&ioport_resource, &res);
- while (conflict->child)
- conflict = ____request_resource(conflict, &res);
- if (!strcmp(conflict->name, "libata"))
- legacy_mode |= ATA_PORT_SECONDARY;
- else {
- pcim_pin_device(pdev);
- printk(KERN_WARNING "ata: 0x%X IDE port busy\n" \
- "ata: conflict with %s\n",
- ATA_SECONDARY_CMD,
- conflict->name);
- }
+ pcim_pin_device(pdev);
+ printk(KERN_WARNING "ata: 0x%X IDE port busy\n",
+ ATA_SECONDARY_CMD);
} else
legacy_mode |= ATA_PORT_SECONDARY;
diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c
index 7f94fc0..75dedc7 100644
--- a/drivers/pci/quirks.c
+++ b/drivers/pci/quirks.c
@@ -1307,119 +1307,6 @@ static void __init quirk_alder_ioapic(struct pci_dev *pdev)
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_EESSC, quirk_alder_ioapic );
#endif
-enum ide_combined_type { COMBINED = 0, IDE = 1, LIBATA = 2 };
-/* Defaults to combined */
-static enum ide_combined_type combined_mode;
-
-static int __init combined_setup(char *str)
-{
- if (!strncmp(str, "ide", 3))
- combined_mode = IDE;
- else if (!strncmp(str, "libata", 6))
- combined_mode = LIBATA;
- else /* "combined" or anything else defaults to old behavior */
- combined_mode = COMBINED;
-
- return 1;
-}
-__setup("combined_mode=", combined_setup);
-
-#ifdef CONFIG_SATA_INTEL_COMBINED
-static void __devinit quirk_intel_ide_combined(struct pci_dev *pdev)
-{
- u8 prog, comb, tmp;
- int ich = 0;
-
- /*
- * Narrow down to Intel SATA PCI devices.
- */
- switch (pdev->device) {
- /* PCI ids taken from drivers/scsi/ata_piix.c */
- case 0x24d1:
- case 0x24df:
- case 0x25a3:
- case 0x25b0:
- ich = 5;
- break;
- case 0x2651:
- case 0x2652:
- case 0x2653:
- case 0x2680: /* ESB2 */
- ich = 6;
- break;
- case 0x27c0:
- case 0x27c4:
- ich = 7;
- break;
- case 0x2828: /* ICH8M */
- ich = 8;
- break;
- default:
- /* we do not handle this PCI device */
- return;
- }
-
- /*
- * Read combined mode register.
- */
- pci_read_config_byte(pdev, 0x90, &tmp); /* combined mode reg */
-
- if (ich == 5) {
- tmp &= 0x6; /* interesting bits 2:1, PATA primary/secondary */
- if (tmp == 0x4) /* bits 10x */
- comb = (1 << 0); /* SATA port 0, PATA port 1 */
- else if (tmp == 0x6) /* bits 11x */
- comb = (1 << 2); /* PATA port 0, SATA port 1 */
- else
- return; /* not in combined mode */
- } else {
- WARN_ON((ich != 6) && (ich != 7) && (ich != 8));
- tmp &= 0x3; /* interesting bits 1:0 */
- if (tmp & (1 << 0))
- comb = (1 << 2); /* PATA port 0, SATA port 1 */
- else if (tmp & (1 << 1))
- comb = (1 << 0); /* SATA port 0, PATA port 1 */
- else
- return; /* not in combined mode */
- }
-
- /*
- * Read programming interface register.
- * (Tells us if it's legacy or native mode)
- */
- pci_read_config_byte(pdev, PCI_CLASS_PROG, &prog);
-
- /* if SATA port is in native mode, we're ok. */
- if (prog & comb)
- return;
-
- /* Don't reserve any so the IDE driver can get them (but only if
- * combined_mode=ide).
- */
- if (combined_mode == IDE)
- return;
-
- /* Grab them both for libata if combined_mode=libata. */
- if (combined_mode == LIBATA) {
- request_region(0x1f0, 8, "libata"); /* port 0 */
- request_region(0x170, 8, "libata"); /* port 1 */
- return;
- }
-
- /* SATA port is in legacy mode. Reserve port so that
- * IDE driver does not attempt to use it. If request_region
- * fails, it will be obvious at boot time, so we don't bother
- * checking return values.
- */
- if (comb == (1 << 0))
- request_region(0x1f0, 8, "libata"); /* port 0 */
- else
- request_region(0x170, 8, "libata"); /* port 1 */
-}
-DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL, PCI_ANY_ID, quirk_intel_ide_combined );
-#endif /* CONFIG_SATA_INTEL_COMBINED */
-
-
int pcie_mch_quirk;
EXPORT_SYMBOL(pcie_mch_quirk);
diff --git a/include/linux/ioport.h b/include/linux/ioport.h
index 6859a3b..71ea923 100644
--- a/include/linux/ioport.h
+++ b/include/linux/ioport.h
@@ -99,7 +99,6 @@ extern struct resource ioport_resource;
extern struct resource iomem_resource;
extern int request_resource(struct resource *root, struct resource *new);
-extern struct resource * ____request_resource(struct resource *root, struct resource *new);
extern int release_resource(struct resource *new);
extern int insert_resource(struct resource *parent, struct resource *new);
extern int allocate_resource(struct resource *root, struct resource *new,
diff --git a/kernel/resource.c b/kernel/resource.c
index bdb55a3..9bd14fd 100644
--- a/kernel/resource.c
+++ b/kernel/resource.c
@@ -213,27 +213,6 @@ int request_resource(struct resource *root, struct resource *new)
EXPORT_SYMBOL(request_resource);
/**
- * ____request_resource - reserve a resource, with resource conflict returned
- * @root: root resource descriptor
- * @new: resource descriptor desired by caller
- *
- * Returns:
- * On success, NULL is returned.
- * On error, a pointer to the conflicting resource is returned.
- */
-struct resource *____request_resource(struct resource *root, struct resource *new)
-{
- struct resource *conflict;
-
- write_lock(&resource_lock);
- conflict = __request_resource(root, new);
- write_unlock(&resource_lock);
- return conflict;
-}
-
-EXPORT_SYMBOL(____request_resource);
-
-/**
* release_resource - release a previously reserved resource
* @old: resource pointer
*/
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
