In the `cdns_i2c_mrecv()` function the CTRL register of the Cadence I2C
controller is written and read back multiple times. The register value does
not change on its own. So it is possible to remember the just written value
instead of reading it back from the hardware.
Signed-off-by: Lars-Peter Clausen <lars@xxxxxxxxxx>
---
drivers/i2c/busses/i2c-cadence.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/i2c/busses/i2c-cadence.c b/drivers/i2c/busses/i2c-cadence.c
index bec50bfe7aad..93c6d0822468 100644
--- a/drivers/i2c/busses/i2c-cadence.c
+++ b/drivers/i2c/busses/i2c-cadence.c
@@ -613,7 +613,7 @@ static void cdns_i2c_mrecv(struct cdns_i2c *id)
/* Determine hold_clear based on number of bytes to receive and hold flag */
if (!id->bus_hold_flag && id->recv_count <= CDNS_I2C_FIFO_DEPTH) {
- if (cdns_i2c_readreg(CDNS_I2C_CR_OFFSET) & CDNS_I2C_CR_HOLD) {
+ if (ctrl_reg & CDNS_I2C_CR_HOLD) {
hold_clear = true;
if (id->quirks & CDNS_I2C_BROKEN_HOLD_BIT)
irq_save = true;
@@ -624,7 +624,7 @@ static void cdns_i2c_mrecv(struct cdns_i2c *id)
addr &= CDNS_I2C_ADDR_MASK;
if (hold_clear) {
- ctrl_reg = cdns_i2c_readreg(CDNS_I2C_CR_OFFSET) & ~CDNS_I2C_CR_HOLD;
+ ctrl_reg &= ~CDNS_I2C_CR_HOLD;
/*
* In case of Xilinx Zynq SOC, clear the HOLD bit before transfer size
* register reaches '0'. This is an IP bug which causes transfer size
--
2.30.2
