Re: [PATCH 0/3] Ensure Low period of SCL is correct

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





04.04.2022 11:01, Neil Armstrong wrote:
Hi,

On 29/03/2022 00:31, Lucas Tanure wrote:
On Mon, 28 Mar 2022, 21:37 Kevin Hilman, <khilman@xxxxxxxxxxxx> wrote:

Hi Lucas,

Lucas Tanure <tanure@xxxxxxxxx> writes:

The default duty cycle of 33% is less than the required
by the I2C specs for the LOW period of the SCL clock.

So, for 100Khz or less, use 50%H/50%L duty cycle, and
for the clock above 100Khz, use 40%H/60%L duty cycle.
That ensures the low period of SCL is always more than
the minimum required by the specs at any given frequency.

Thanks for the fixes!

This is going to affect all SoCs, so ould you please summarize how your
changes were tested, and on which SoCs & boards?

Thanks,

Kevin

Hi,

I only tested against the vim3 board, measured the bus with a Saleae
logic pro 16.
The measurements were with 100k, 400k, and a few in-between frequencies.

Thanks, it's a great addition to have !


Is that enough?

A test on GXL/GXM (VIM1 or VIM2) & GXBB (Odroid-C2) devices is lacking before we
can merge this.

If I find some time, I'll have a try, but everyone is welcome testing this serie
and report if it still works fine for them.

Vyacheslav, do you think you can test on your JetHub devices ? it would validate GXL & AXG.

It builds ok on 5.17. JetHub H1/D1 has only rtc clock (pcf8563) and 1-wire controller (ds2482) on i2c bus. I did't see any difference with or without patches. all works at first look.

Vyacheslav




[Index of Archives]     [Linux GPIO]     [Linux SPI]     [Linux Hardward Monitoring]     [LM Sensors]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux