Append bindings to support transfer mode.
Signed-off-by: Jae Hyun Yoo <jae.hyun.yoo@xxxxxxxxxxxxxxx>
---
Changes since v2:
- Moved SRAM resources back to default dtsi and added a mode selection
property.
Changes since v1:
- Removed buffer reg settings from default device tree and added the settings
into here to show the predefined buffer range per each bus.
.../devicetree/bindings/i2c/i2c-aspeed.txt | 37 +++++++++++++++----
1 file changed, 30 insertions(+), 7 deletions(-)
diff --git a/Documentation/devicetree/bindings/i2c/i2c-aspeed.txt b/Documentation/devicetree/bindings/i2c/i2c-aspeed.txt
index b47f6ccb196a..242343177324 100644
--- a/Documentation/devicetree/bindings/i2c/i2c-aspeed.txt
+++ b/Documentation/devicetree/bindings/i2c/i2c-aspeed.txt
@@ -17,6 +17,20 @@ Optional Properties:
- bus-frequency : frequency of the bus clock in Hz defaults to 100 kHz when not
specified
- multi-master : states that there is another master active on this bus.
+- aspeed,i2c-xfer-mode : should be "byte", "buf" or "dma" to select transfer
+ mode defaults to "byte" mode when not specified.
+
+ I2C DMA mode on AST2500 has these restrictions:
+ - If one of these controllers is enabled
+ * UHCI host controller
+ * MCTP controller
+ I2C has to use buffer mode or byte mode instead
+ since these controllers run only in DMA mode and
+ I2C is sharing the same DMA H/W with them.
+ - If one of these controllers uses DMA mode, I2C
+ can't use DMA mode
+ * SD/eMMC
+ * Port80 snoop
Example:
@@ -26,20 +40,29 @@ i2c {
#size-cells = <1>;
ranges = <0 0x1e78a000 0x1000>;
- i2c_ic: interrupt-controller@0 {
- #interrupt-cells = <1>;
- compatible = "aspeed,ast2400-i2c-ic";
+ i2c_gr: i2c-global-regs@0 {
+ compatible = "aspeed,ast2500-i2c-gr", "syscon";
reg = <0x0 0x40>;
- interrupts = <12>;
- interrupt-controller;
+
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0x0 0x0 0x40>;
+
+ i2c_ic: interrupt-controller@0 {
+ #interrupt-cells = <1>;
+ compatible = "aspeed,ast2500-i2c-ic";
+ reg = <0x0 0x4>;
+ interrupts = <12>;
+ interrupt-controller;
+ };
};
i2c0: i2c-bus@40 {
#address-cells = <1>;
#size-cells = <0>;
#interrupt-cells = <1>;
- reg = <0x40 0x40>;
- compatible = "aspeed,ast2400-i2c-bus";
+ reg = <0x40 0x40>, <0x200 0x10>;
+ compatible = "aspeed,ast2500-i2c-bus";
clocks = <&syscon ASPEED_CLK_APB>;
resets = <&syscon ASPEED_RESET_I2C>;
bus-frequency = <100000>;
--
2.17.1
