Change the iProc I2C driver to use the 'BIT' macro from all '1 << XXX' bit operations to get rid of compiler warning and improve readability of the code Signed-off-by: Ray Jui <ray.jui@xxxxxxxxxxxx> --- drivers/i2c/busses/i2c-bcm-iproc.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/i2c/busses/i2c-bcm-iproc.c b/drivers/i2c/busses/i2c-bcm-iproc.c index 562942d0c05c..a845b8decac8 100644 --- a/drivers/i2c/busses/i2c-bcm-iproc.c +++ b/drivers/i2c/busses/i2c-bcm-iproc.c @@ -717,7 +717,7 @@ static int bcm_iproc_i2c_xfer_single_msg(struct bcm_iproc_i2c_dev *iproc_i2c, /* mark the last byte */ if (i == msg->len - 1) - val |= 1 << M_TX_WR_STATUS_SHIFT; + val |= BIT(M_TX_WR_STATUS_SHIFT); iproc_i2c_wr_reg(iproc_i2c, M_TX_OFFSET, val); } @@ -844,7 +844,7 @@ static int bcm_iproc_i2c_cfg_speed(struct bcm_iproc_i2c_dev *iproc_i2c) iproc_i2c->bus_speed = bus_speed; val = iproc_i2c_rd_reg(iproc_i2c, TIM_CFG_OFFSET); - val &= ~(1 << TIM_CFG_MODE_400_SHIFT); + val &= ~BIT(TIM_CFG_MODE_400_SHIFT); val |= (bus_speed == 400000) << TIM_CFG_MODE_400_SHIFT; iproc_i2c_wr_reg(iproc_i2c, TIM_CFG_OFFSET, val); @@ -995,7 +995,7 @@ static int bcm_iproc_i2c_resume(struct device *dev) /* configure to the desired bus speed */ val = iproc_i2c_rd_reg(iproc_i2c, TIM_CFG_OFFSET); - val &= ~(1 << TIM_CFG_MODE_400_SHIFT); + val &= ~BIT(TIM_CFG_MODE_400_SHIFT); val |= (iproc_i2c->bus_speed == 400000) << TIM_CFG_MODE_400_SHIFT; iproc_i2c_wr_reg(iproc_i2c, TIM_CFG_OFFSET, val); -- 2.17.1
