Hello,
I encountered bug in SX1502 expander driver in 5.7.7. Here is relevant
DTS part:
compatible = "semtech,sx1502q";
gpio4_cfg_pins: gpio2-cfg {
pins = "gpio5";
output-high;
};
And part of OOPS:
[ 0.673996] [<c023cfa6>] (gpiochip_get_data) from [<c023b235>]
(sx150x_gpio_direction_output+0xd)
[ 0.683259] [<c023b235>] (sx150x_gpio_direction_output) from
[<c023b363>] (sx150x_pinconf_set+0x)
[ 0.692796] [<c023b363>] (sx150x_pinconf_set) from [<c0238fef>]
(pinconf_apply_setting+0x39/0x7e)
[ 0.701635] [<c0238fef>] (pinconf_apply_setting) from [<c0236c77>]
(pinctrl_commit_state+0xa5/0x)
[ 0.710648] [<c0236c77>] (pinctrl_commit_state) from [<c0237e03>]
(pinctrl_enable+0xff/0x1d4)
[ 0.719139] [<c0237e03>] (pinctrl_enable) from [<c023b791>]
(sx150x_probe+0x1a3/0x358)
[ 0.727027] [<c023b791>] (sx150x_probe) from [<c02c38bf>]
(i2c_device_probe+0x1bb/0x1dc)
The problem is that sx150x_pinconf_set uses sx150x_gpio_direction_output
but gpio is not
setup yet. Patch below fixes it but I'm not sure whether is it correct:
diff --git a/drivers/pinctrl/pinctrl-sx150x.c
b/drivers/pinctrl/pinctrl-sx150x.c
index 6e74bd87d959..3f5651edd336 100644
--- a/drivers/pinctrl/pinctrl-sx150x.c
+++ b/drivers/pinctrl/pinctrl-sx150x.c
@@ -1154,12 +1154,6 @@ static int sx150x_probe(struct i2c_client *client,
return ret;
}
- ret = pinctrl_enable(pctl->pctldev);
- if (ret) {
- dev_err(dev, "Failed to enable pinctrl device\n");
- return ret;
- }
-
/* Register GPIO controller */
pctl->gpio.base = -1;
pctl->gpio.ngpio = pctl->data->npins;
@@ -1191,6 +1185,12 @@ static int sx150x_probe(struct i2c_client *client,
if (ret)
return ret;
+ ret = pinctrl_enable(pctl->pctldev);
+ if (ret) {
+ dev_err(dev, "Failed to enable pinctrl device\n");
+ return ret;
+ }
+
ret = gpiochip_add_pin_range(&pctl->gpio, dev_name(dev),
0, 0, pctl->data->npins);
if (ret)
