Hi Miquel, On sam., avril 21 2018, Miquel Raynal <miquel.raynal@xxxxxxxxxxx> wrote: > From: Ken Ma <make@xxxxxxxxxxx> > > Add suspend/resume hooks in pinctrl driver to handle S2RAM operations. > > Beyond the traditional register save/restore operations, these hooks > also keep the GPIOs used for both-edge IRQ synchronized between their > level (low/high) and expected IRQ polarity (falling/rising edge). > > Since pinctrl is an infrastructure module, its resume should be issued > prior to other IO drivers. The pinctrl PM is registered as syscore > level to make sure of it. A postcore initcall is added to register > syscore operation. Because of the use of such syscore_ops, the > suspend/resume hooks do not have access to a device pointer, and thus > need to use a global list in order to keep track of the probed devices > for which registers have to be saved/restored. Did you consider to use SET_LATE_SYSTEM_SLEEP_PM_OPS ? [...] > +#if defined(CONFIG_PM) > +static int armada_3700_pinctrl_suspend(void) > +{ > + struct armada_37xx_pinctrl *info; > + > + list_for_each_entry(info, &device_list, node) { > + /* Save GPIO state */ > + regmap_read(info->regmap, OUTPUT_EN, &info->pm.out_en_l); > + regmap_read(info->regmap, OUTPUT_EN + sizeof(u32), > + &info->pm.out_en_h); > + regmap_read(info->regmap, OUTPUT_VAL, &info->pm.out_val_l); > + regmap_read(info->regmap, OUTPUT_VAL + sizeof(u32), > + &info->pm.out_val_h); > + > + info->pm.irq_en_l = readl(info->base + IRQ_EN); > + info->pm.irq_en_h = readl(info->base + IRQ_EN + sizeof(u32)); > + info->pm.irq_pol_l = readl(info->base + IRQ_POL); > + info->pm.irq_pol_h = readl(info->base + IRQ_POL + sizeof(u32)); > + > + /* Save pinctrl state */ > + regmap_read(info->regmap, SELECTION, &info->pm.selection); I thought there was an API with regmap which allow to save all the register in one call. If it is the case it woudl be nice to use it. Gregory -- Gregory Clement, Bootlin (formerly Free Electrons) Embedded Linux and Kernel engineering http://bootlin.com -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html