On Mon, Mar 01, 2021 at 04:42:26PM +0100, Sedat Dilek wrote: > On Mon, Mar 1, 2021 at 4:34 PM Theodore Ts'o <tytso@xxxxxxx> wrote: > > > > On Mon, Mar 01, 2021 at 04:12:03PM +0100, Sedat Dilek wrote: > > > > > > OK, I see. > > > So I misunderstood the -o option. > > > > It was clearly documented in the man page: > > > > -o output_file > > Write the list of bad blocks to the specified file. > > Without this option, badblocks displays the list on > > its standard output. The format of this file is > > suitable for use by the -l option in e2fsck(8) or > > mke2fs(8). > > > > RTFM. > > > I will say that for modern disks, the usefulness of badblocks has > > decreased significantly over time. That's because for modern-sized > > disks, it can often take more than 24 hours to do a full read on the > > entire disk surface --- and the factory testing done by HDD > > manufacturers is far more comprehensive. > > > > In addition, SMART (see the smartctl package) is a much more reliable > > and efficient way of judging disk health. > > > > The badblocks program was written over two decades ago, before the > > days of SATA, and even IDE disks, when disk controlls and HDD's were > > far more primitive. These days, modern HDD and SSD will do their own > > bad block redirection from a built-in bad block sparing pool, and the > > usefulness of using badblocks has been significantly decreased. > > > > Thanks for the clarification on badblocks usage and usefulness. > > OK, I ran before badblocks: > > 1. smartctl -a /dev/sdc (shell) > 2. gsmartcontrol (GUI) > > The results showed me "this disk is healthy". > As you said: Both gave a very quick overview. > > - Sedat - Just note that not even the device firmware can't really know whether the block is good/bad unless it tries to read/write it. In that way I still find the badblocks useful because it can "force" the device to notice that there is something wrong and try to fix it (perhaps by remapping the bad block to spare one). Of course you could use dd for that, but there are several reasons why badblocks is still more convenient tool to do that. That said you should also check the SMART data _after_ you run the badblocks to see if it encountered any read errors and/or remapped some blocks. -Lukas > > [1] https://superuser.com/questions/171195/how-to-check-the-health-of-a-hard-drive >
