Hello, I own Gigabyte U7000 DVB-T receiver with integrated remote IR receiver. Receiver is working but I have problems with IR receiver. Dmesg reports: [15276.779498] usb 5-3: new high speed USB device using ehci_hcd and address 8 [15276.913366] usb 5-3: configuration #1 chosen from 1 choice [15276.913592] usb 5-3: New USB device found, idVendor=1044, idProduct=7001 [15276.913596] usb 5-3: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [15276.913598] usb 5-3: Product: U7000 [15276.913599] usb 5-3: Manufacturer: GIGABYTE [15276.913601] usb 5-3: SerialNumber: 000000000000001 [15277.065012] dib0700: loaded with support for 9 different device-types [15277.068972] dvb-usb: found a 'Gigabyte U7000' in cold state, will try to load a firmware [15277.068972] firmware: requesting dvb-usb-dib0700-1.20.fw [15277.080974] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-1.20.fw' [15277.290166] dib0700: firmware started successfully. [15277.801546] dvb-usb: found a 'Gigabyte U7000' in warm state. [15277.801583] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. [15277.801803] DVB: registering new adapter (Gigabyte U7000) [15278.160819] DVB: registering adapter 0 frontend 0 (DiBcom 7000PC)... [15278.164724] MT2060: successfully identified (IF1 = 1220) [15278.658557] input: IR-receiver inside an USB DVB receiver as /class/input/input15 [15278.673297] dvb-usb: schedule remote query interval to 50 msecs. [15278.673302] dvb-usb: Gigabyte U7000 successfully initialized and connected. [15278.673491] usbcore: registered new interface driver dvb_usb_dib0700 When I press key on remote: [15089.153588] dib0700: Unknown remote controller key: D 78 1 0 By the way, I use firmware version 1.1 because there are problems with v. 1.2 (keys are simply not detected, even if I use force_lna_activation=1). In source code of module dvb_usb_dib0700 I can see that my remote control is not supported. Supported remotes have hardcoded key maping. I could manually add keymap to driver, but I would like to do mapping in userspace with LIRC. I have seen a lot of howto's telling me to use proper /dev/input/event? socket but driver only sends resolved keys to it. If remote controller key is not recognized I only get "Unknown remote key.." line in kernel log, /dev/input/eventX stays silent. What should I do to get key codes directly to /dev/input/eventX socket without mapping them in dvb_usb_dib0700? Or is there any other way to make remote controller work? Thanks and best regards, Miha Furlan _______________________________________________ linux-dvb users mailing list For V4L/DVB development, please use instead linux-media@xxxxxxxxxxxxxxx linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
